There are 0 repository under opamp topic.
Electronic Modules
A few libs, including a lot of Commodore / CSG parts
This project is about designing a 1.5 bit stage Pipeline ADC & the OpAmp required for its MDAC.
Schematic, Layout Design & Simulation in 180nm Technology
1/2 channel 4-20 mA to voltage converter boards using LMP8640 current sense monitor.
《电子系统设计-基础和测量系统篇》理论计算用Mathematica代码
A simple yet powerful dummy/electronic load, with minimum component requirements and a lot use cases.
TA Ship work and Various other Projects done using LTSpice for the fulfilment of Analog Electronics Course at BITS Pilani.
Headphone Amplifier project featuring the NE5532 OP-Amp and a powerful Class AB output stage
voltage and current regulated power supply
Learn to design and build an 4 channel LM35 temperature sensor chip Signal conditioner amplifier circuit based on the popular opamp LM324 using Kicad 6.0.The board can be used to monitor temperature from 4 different sources at the same time and can be used for building your own data acquisition system.
Comparative Analysis of Machine Learning Models for Aspect Ratio Estimation of a Two-Stage Operational Amplifier
Analog Electronics simulation and design, these are some of my junior year labs for Analog Electronics
Accurate and high-current analog function generator
This MCC based MPLAB X IDE example shows how to interface an electret microphone with a microcontroller (MCU) using the Analog Signal Conditioning (OPAMP). In addition to the microphone, only one resistor and one capacitor are required.
Analog Circuit design using ABC algorithm
A 2 stage CMOS OTA with Differential amplifier with active load as the first stage followed by Common Source stage using Cadence
Continuous-measurement sound-level meter with Wi-Fi connectivity, to be integrated into the sensor network of the Escuela Politécnica de Cáceres
This is a Mini Project assigned in the subject CMOS Analog and VLSI design at IITB.
Studying and analyzing a Zero Crossing Detector using OpAmp and Optocoupler
This circuit uses two quad operational amplifiers to scale a bi-polar input signal to be sampled by a 0-3.3V ADC that is common on microcontrollers
Design and Layout implementation of a high-performance two-stage Operational Amplifier (OPAMP) using180nm semiconductor technology. Achieved required gain, bandwidth, and power efficiency through simulation and characterization.
Designed a relay logic circuit to mimick the Micro-controller, opamps to amplify the sensor voltages, sensors used: Temperature sensor, LDR.
frequency counter with display and analog scheme
Component value calculator for scaling and offset amplifier circuits and lowpass filters using Texas Instrumetns application notes
This MCC based MPLAB X example shows how to calibrate the gain and offset of the OPAMP when configured as a Programmable Gain Amplifier (PGA). The internal DAC and ADC are used to perform the calibration procedure. No external components are required.
Karaoke system built with Op-amps and RC filters. Simulated the circuit in Proteus.
A folded-cascode OTA with 3.3V power supply and 54.27 dB DC gain with 66.8MHz unity frequency
Design of various circuits using operational amplifiers
OpAmp Design as part of the class Electronics 3, 7th semester, ECE Aristotle University of Thessaloniki.
Tool for configuring op amps. Works for inverting and non-inverting configs, with optional input and output offsets.
A demo based on the dual op amps on the q71, and their configurations within mcc.