mlab-module
There are 0 repository under mlab-module topic.
- ISM01
mlab-modules / ISM01
High-performance wireless transceiver, ideal for remote control, data links, and sensor networks.
Language:HTML 8 - USBI2C01
USB device to I²C master adapter with Linux kernel support
Language:HTML 8 Differential pressure wind speed sensor with magnetometer.
Language:G-code 7- DRV10987V01
Sensorless driver of BLDC and PMSM motors based on DRV10987 controller.
Language:Jupyter Notebook 6 - GPS02
GNSS reciever ready to RTK (Real time kinematics) technology
Language:HTML 6 - USBPDSINK01
USB power delivery solution for charging, or as a universal power source.
Language:HTML 5 Multiple parallel Li-ion 18650 battery cell module with BMS and data storage with MCU control.
Language:HTML 4Silicon PIN diode cosmic radiation detector
Language:HTML 4VLF antenna connection module
Direct conversion IQ output SDR receiver.
Audio to digital converter ADCaudio01B Module has audio input interface. Digitalized audio data stream (I2S) with parametrers 192kHz@24bit.
Octal input high-speed ADC with LVDS parallel output.
- ALTIMET02
High-accuracy barometric pressure and temperature sensing module with MS561101BA03.
Language:HTML 2 8 Mbit FRAM (CY15B108QN) fast data write, low power consumption, and high radiation resistance data storage
Language:HTML 2- LIGHTNING01
Lightning sensor module based on AS3935 Franklin Lightning Sensor IO. Sensor can be connected via I2C or SPI bus.
Language:HTML 2 Dual-cell Li-Ion Battery management system.
Language:G-code 2Silicon PIN diode cosmic radiation detector
Language:HTML 2The module uses well known MAX232 chip and is intended as a level converter. It uses RX/TX signals and a pair of flow control signals (selectable by jumpers). Original RS232 signals are available on header pins.
Small low-power MPPT module for photovoltaic cells.
- USB232R02
Universal USB-UART converter ideal for prototyping high-quality devices. USB Full Speed/Full Handshake support.
Language:HTML 2 - Language:OpenSCAD 2
Module is audio in and audio out interface for development board NGW100 with processor ATMEL AVR32. It uses common codec AD1881A.
Mono high speed analog to digital converter. With parallel data output.
SMD construction of band pass filter intented to be used in radioastronomy applications. Primarily designed to 20-40MHz pass band.
- GH4PIN01
This 4-pin module connects JST-GH connectors, often used in Pixhawk drones, to standard pin headers, making it easier to build custom electronics and use I2C or CAN bus communication.
Language:HTML 1 - PROGLOG01
Small low-power open-source toolchain compatible FPGA
Language:HTML 1 The wide bandwidth logarithmic amplifier and detector is suitable for radio frequency measurement.
The module contains the AS5048B integrated circuit, which allows the measurement of the magnetic field perpendicular to the surface of the integrated circuit. The module is suitable for measuring the angular position of a magnet and constructing tachometers. The communication interface is I2C.
Xilinx Spartan 3 XC3S50AN FPGA School Board
- SHT31V01
High precission SHT3x hygrometer (humidity and temperature sensor) in form of MLAB module.
Language:Python 1 Silicon photomultiplier (SiPM) analog front end
Language:HTML 1- Language:Makefile 1
Circuit for charging and balancing two supercapacitors usable as UPS.
Language:Python 1TTL to LVDS translating module.
USB to I2S converter for interfacin I2S audio devices to standard USB port. It is compatible with UAC standard.