OpenCR (Open-source Control Module for ROS) is developed for ROS embedded systems to provide completely open-source hardware and software.
Everything about the board; Schematics, PCB Gerber, BOM and the firmware source code for the TurtleBot3 and OP3 are free to distribute under open-source licenses for users and the ROS community. The STM32F7 series chip inside the OpenCR1.0 board is based on a very powerful ARM Cortex-M7 with floating point unit. The development environment for OpenCR1.0 is wide open from Arduino IDE and Scratch for young students to traditional firmware development for the expert.
- OpenCR
- OpenCR-Hardware
- OpenCM 9.04
- dynamixel_sdk
- dynamixel_workbench
- turtlebot3
- open_manipulator
- robotis_op3
- ROBOTIS e-Manual for OpenCR
- ROBOTIS e-Manual for OpenCM 9.04
- ROBOTIS e-Manual for OpenCM 485 Expansion Board
- ROBOTIS e-Manual for Dynamixel SDK
- ROBOTIS e-Manual for Dynamixel Workbench
- ROBOTIS e-Manual for TurtleBot3
- ROBOTIS e-Manual for OpenManipulator
- ROBOTIS e-Manual for ROBOTIS OP3
- Videos for OpenCR
- Schematic
- OrCAD Capture 16.6