openbmc / phosphor-networkd

openbmc/phosphor-networkd Issues

ipmitool lan print error
Updated 4 months ago
Why does phosphor-network change full ipv6 to short form?
Updated 7 months ago1
Failed to set IPv6 DHCP from static config
Closed 3 years ago2
dhcp fails to obtain an ip address
Updated 9 months ago12
MAC address is not persistent on Rebooting the system.
Updated 9 months ago25
System not getting up After configuring valid mac address and even on waiting 120 seconds.
Updated 9 months ago8
BMC allows us to configure reserved IP addresses like Loopback, Broadcast, Network ID & multicast IP addreses
Updated 9 months ago13
BMC does not throw error on configuring some invalid MAC address
Closed 2 years ago10
VLAN is not created via ipmitool
Closed 10 months ago2
Crashed when trying to set VLAN id from IPMI command if DHCP is enabled
Updated 10 months ago2
Network configuration changes don't show on D-Bus until ~5-10 seconds after
Closed a year ago3
SLAAC valid lifetime is not getting updated properly
Closed a year ago3
Support multiple IPv6 Static default gateways
Updated a year ago5
No Docs for the configuration of DNS server in OpenBMC.
Updated a year ago1
No IPv4/IPv6 address in RedFish after certain phosphor-network commit
Closed a year ago9
systemd config files are not generated after BMC factory reset
Closed a year ago3
IP configuration is not persistent on Disabling Interface and enabling back.
Updated a year ago6
Address Origin "Static" populated for IPv6 addresses when DHCPv6 disabled
Updated a year ago4
Regression: IPMI managment of IPv4 static addresses have numerous behavioral issues
Updated a year ago3
Unable to restore IPv6 RA and DHCPv6 client via IPMI Set LAN Config
Updated a year ago1
wake on lan in openbmc
Closed 2 years ago2
BMC does not throw error on configuring some invalid MAC address
Closed 2 years ago3
Disconnected port IP
Updated 2 years ago2
BMC is not getting configured with zero config address when there is no DHCP server
Updated 2 years ago2
wake on lan in openbmc
Closed 2 years ago
After host reboot, eth0 source switch from DHCP to static IP
Closed 2 years ago2
VLAN is not created via ipmitool or curl command
Closed 2 years ago3
OpenBMC networking doesn't respect RFC3927 - Autoconfigured Link-Local address issue
Closed 2 years ago2
BMC is not using NTP server/s sent by DHCP server
Closed 2 years ago3
NTP server that is configured via DHCP, is not shown in redfish command
Closed 2 years ago2
Degraded Eth0 and Eth1
Closed 2 years ago
BMC is not extracting Domain Name & configuring it on BMC
Closed 2 years ago5
Didn't find service unit 'ncsi-netlink.service'
Closed 3 years ago2
phosphor-network-manager[1345]: ip: wrong address (70) length: expected 4 bytes
Closed 3 years ago3
Bad routing table - Duplicate entries.
Closed 3 years ago4
Gateway should be per-interface, ideally generalized to routes
Closed 3 years ago3
when multiple DNS servers are sent in DHCP response BMC will have only 1 entry
Closed 3 years ago2
The DHCPEnabled property within the EthernetInterfaces YAML is not a boolean
Closed 3 years ago1
DNS server that is configured via DHCP, is not shown in redfish command
Closed 3 years ago6
Failed to set gateway via ipmitool
Closed 3 years ago3
Default gateway missing when multiple gateway are configured
Closed 3 years ago7
Failed to set static ip after setting the ipsrc to static from dhcp
Closed 3 years ago6
eth0 stuck in configuring, systemd-networkd-wait-online fails intermittently
Closed 3 years ago1
Failed to set the same static IP address from DHCP
Closed 3 years ago3
Endless cycle in toV6Cidr function
Closed 3 years ago3
phosphor-network-manager consumes all CPU on DHCPv6
Closed 3 years ago3
getNameServerFromResolvd function can't parse IPv6 nameserver address in right way
Closed 3 years ago1
ioctl failed for SIOCETHTOOL
Closed 4 years ago3
EthernetInterface LinkUp property value read from D-bus.
Closed 4 years ago1
Re-enable networkd unit tests
Closed 5 years ago1