Mark's repositories

Bed_Distance_sensor

Auto bed level with High resolution distance sensor

PandaPi

3d printer firmware run on raspberry pi directly

PandaCAN

CAN bus extruder, more resistant to noise,reduce a lot of wires for your 3D printer

PandaZHU

3D printer control board based on ESP32,support 8 Driver motors.

Laser-Filament-Motion-Sensor

Independent laser motion sensor to sense filament clog or runout

Stargazers:21Issues:0Issues:0

klipper

for Bed Distance Sensor

Language:CLicense:GPL-3.0Stargazers:5Issues:1Issues:0

Panda_LCD800480D

Dgus LCD 800*480,Capacitive touch screen,serial,4.3inch, for PandaPi 3D printer control board

PandaSegmentHeatBed

SoftMasterI2C for arduino

Language:C++Stargazers:4Issues:0Issues:0

klipper_pull

Klipper is a 3d-printer firmware

Language:CLicense:GPL-3.0Stargazers:1Issues:0Issues:0

Robot-Sheep-Project

Rsheep app is an android web based app, so you can change its code or add your html5 code in it.

Language:JavaScriptStargazers:1Issues:1Issues:0

Android-phone-telepresence-robot

use android phone as robot brain

Language:CStargazers:0Issues:2Issues:1
Language:JavaScriptStargazers:0Issues:2Issues:0

MarlinPULL

Marlin is an optimized firmware for RepRap 3D printers based on the Arduino platform. Many commercial 3D printers come with Marlin installed. Check with your vendor if you need source code for your specific machine.

Language:C++License:GPL-3.0Stargazers:0Issues:0Issues:0
Language:C++License:GPL-2.0Stargazers:0Issues:2Issues:0