Raspi9116's starred repositories
Console-Service-Tool
Console Service Tool - Playstation 5 UART Code Reader and NOR Tool.
esp32-ble-gateway
WiFi to BLE gateway on ESP32
esp8266FTPServer
Simple FTP Server for using esp8266/esp32 SPIFFs
self-balancing-cube
Code for a self balancing cube I'm building for module corsework
popup-chat
esp8266 instant message board/chat room - runs as open wifi access point (captive portal)
esp32-telegram-dooralarm
sending telegram notifications from a esp32 that contain the status of a connected reedswitch
push-notifications-arduino-esp8266
Example of how to generate push notifications on your phone from your ESP8266 using the Arduino IDE.
badusb_sd_wifi
BadUSB with WiFi that allows to execute payloads from SD
upsplus
UPS Plus is a new generation of UPS power management module. It is an improved version of the original UPS prototype. It has been fixed the bug that UPS could not charge and automatically power off during work time. It can not only perform good battery power management, but also provide stable voltage output and RTC functions. At the same time,it support for FCP, AFC, SFCP fast charge protocol, support BC1.2 charging protocol, support battery terminal current/voltage monitoring and support two-way monitoring of charge and discharge. It can provide programmable PVD function. Power Voltage Detector (PVD) can be used to detect if batteries voltage is below or above configured voltage. Once this function has been enabled, it will monitoring your batteries voltage, and you can control whether or not shut down Raspberry Pi via simple bash script or python script. This function will protect your batteries from damage caused by excessive discharge. It can provide Adjustable data sampling Rate. This function allows you to adjust the data sampling rate so that you can get more detailed battery information and also it will consume some power. The data sampling information can communicate with the upper computer device through the I2C protocol. UPS Plus supports the OTA firmware upgrade function. Once there is a new firmware update, it is very convenient for you to upgrade firmware for UPS Plus. The firmware upgrade can be completed only by connecting to the Internet,and execute a python script. Support battery temperature monitoring and power-down memory function. UPS Plus can be set to automatically start the Raspberry Pi after the external power comes on. The programmable shutdown and forced restart function will provide you with a remote power-off restart management method. That means you don’t need to go Unplug the power cable or press the power button to cut off the power again. You can set the program to disconnect the power supply after a few seconds after the Raspberry Pi is shut down properly. And you can also reconnect the power supply after a forced power failure to achieve a remote power-off and restart operation. Once it was setting up, you don't need to press power button to boot up your device which is very suitable for smart home application scenarios.
DuinoCoinUSB_ESP8266
This project design to mine Duino-Coin using an ESP8266 via USB-Serial
DuinoCoinI2C_RPI
This project design to mine Duino-Coin using Raspberry Pi or equivalent SBC as a master and Arduino/ATTiny as a slave.
NonceSet112
NonceSet1112 for iOS 11.1.2 exploit based
esp8266_deauther
Affordable WiFi hacking platform for testing and learning
Storm-Breaker
Social engineering tool [Access Webcam & Microphone & Location Finder] With {Py,JS,PHP}
ArduinoJoystickLibrary
An Arduino library that adds one or more joysticks to the list of HID devices an Arduino Leonardo or Arduino Micro can support.