PyCurvelab - Python Wrappers for CurveLab
The software allows to compute Curvelet Transforms from Python 2.
This software is release under GPL version 2.
Pre-requisites:
-
Python -> version 2.3 or above -> http://www.python.org
-
SWIG -> version 1.3 or above -> http://www.swig.org
-
Numpy -> module must be available in your PYTHONPATH environment variable in order to be found by -> version 1.0 or above -> http://numpy.scipy.org/
-
CurveLab -> version 2.0.2 or above -> http://www.curvelet.org
Installation:
-
Clone this repsitory.
-
Set these required environment variables:
- FDCT: folder where your CurveLab installation is
- FFTW: folder where your fftw installation is
-
In the PyCurvelab folder, run the following command:
- python setup.py build install
- the package will be installed as pyct module
-
In python, simply "import pyct" and you're off
-
To see how to use, type "help(pyct.fdct2)" or "help(pyct.fdct3)"
setup.py uses python's distutils, which offers many options for a customized installation. run "python setup.py install --help" for more information
Original Authors
This software was written by Darren Thomson and Gilles Hennenfent from SLIM group at University of British Columbia.
Address
SLIM Software Administrator (softadmin@slimweb.eos.ubc.ca)
Seismic Laboratory for Imaging and Modeling
Dept. of Earth, Ocean, and Atmospheric Sciences
The University of British Columbia