urish / ng2-simon

Simon Game for angular2-iot

ng2-simon

A Universal Simon game written in Angular 2.

It runs on the web browser, on Arduino and also on the Raspberry PI using angular2-iot.

➡ Learn how to works and how you can build your own version

Live Demo (browser)

Go to the online version

Running in a Web Browser

npm install
npm start

Then go to http://localhost:3000 in your browser.

Running on Raspberry Pi

Hardware Assembly

1. Connect 4 push-buttons, one button between each of pins GPIO-13, GPIO-26, GPIO-16, GPIO-21 and the ground
2. Connect 4 colored LEDs, one LED between each of pins GPIO-6, GPIO-19, GPIO-12, GPIO-20 and the ground. It is also recommended to add a 100ohm current limiting resistor in series with each LED.
3. Connect a speaker to the Raspberry PI audio jack
4. Optionally, connect a Serial 7-Segment Display to the I2C pins of the Raspberry Pi: connect GPIO-2 to SDL and GPIO-3 to SCL

Running the game

Run the following command on the Raspberry pi terminal / console:

1. Make sure you have the sox and mpg123 packages installed: sudo apt-get install sox mpg123
2. Build the project using npm run build:iot
3. Run it using sudo npm run iot

Running on Arduino

Hardware Assembly

1. Connect 4 push-buttons, one button between each of Arduino pins 2, 3, 4, 5 and the ground
2. Connect 4 colored LEDs, one LED between each of Arduino pins 9, 10, 11, 12 and a current limiting resistor connected to the ground. 220ohm is a good value for the resistor.
3. Optionally, connect a small speaker between pin 8 and the ground

Running the game

1. Connect the Arduino board to your computer
2. Upload the StandardFirmata firmware firmware to your Arduino board
3. Build the project using npm run build:iot
4. Run it using npm run iot