[Modified from the android-rpi original to use the automotive specific config] Read it first : https://github.com/snappautomotive/firmware_rpi-local_manifests # Build Kernel $ sudo apt install gcc-aarch64-linux-gnu libssl-dev $ cd kernel/arpi $ ARCH=arm64 scripts/kconfig/merge_config.sh arch/arm64/configs/bcm2711_defconfig kernel/configs/android-base.config kernel/configs/android-recommended.config $ ARCH=arm64 CROSS_COMPILE=aarch64-linux-gnu- make Image.gz $ ARCH=arm64 CROSS_COMPILE=aarch64-linux-gnu- DTC_FLAGS="-@" make broadcom/bcm2711-rpi-4-b.dtb $ ARCH=arm64 CROSS_COMPILE=aarch64-linux-gnu- DTC_FLAGS="-@" make overlays/vc4-kms-v3d-pi4.dtbo # Patch framework source https://github.com/android-rpi/device_arpi_rpi4/wiki/arpi-11-:-framework-patch # Build Android source Continue build referring to http://source.android.com/source/building.html $ source build/envsetup.sh $ lunch snapp_car_rpi4-eng $ make ramdisk systemimage vendorimage Use -j[n] option with make, if build host has a good number of CPU cores. # Prepare sd card Partitions of the card should be set-up like followings. p1 128MB for boot : Do fdisk, set W95 FAT32(LBA) & Bootable type, mkfs.vfat p2 2048MB for /system : Do fdisk, new primary partition p3 128MB for /vendor : Do fdisk, new primary partition p4 remainings for /data : Do fdisk, mkfs.ext4 Set volume label of /data partition as userdata : use -L option for mkfs.ext4, and -n option for mkfs.vfat # Write system & vendor partition $ cd out/target/product/rpi $ sudo dd if=system.img of=/dev/<p2> bs=1M $ sudo dd if=vendor.img of=/dev/<p3> bs=1M # Copy kernel & ramdisk to BOOT partition device/snappautomotive/rpi/boot/* to p1:/ kernel/arpi/arch/arm64/boot/Image.gz to p1:/ kernel/arpi/arch/arm64/boot/dts/broadcom/bcm2711-rpi-4-b.dtb to p1:/ kernel/arpi/arch/arm64/boot/dts/overlays/vc4-kms-v3d-pi4.dtbo to p1:/overlays/ out/target/product/rpi/ramdisk.img to p1:/