Error, no UBI device selected!
Final-Resolution opened this issue · comments
I want to make my own firmware, but the serial port output is as follows after burning, I hope to get help, thank you!
U-Boot SPL 2019.04 (Nov 26 2021 - 20:51:43 -0800)
DRAM: 32 MiB
SPL: Unsupported Boot Device!
Trying to boot from sunxi SPI
U-Boot 2019.04 (Nov 26 2021 - 20:51:43 -0800) Allwinner Technology
CPU: Allwinner F Series (SUNIV)
Model: George Hilliard's business card
DRAM: 32 MiB
In: serial@1c25000
Out: serial@1c25000
Err: serial@1c25000
Hit any key to stop autoboot: 0
SF: Detected xt25f128b with page size 256 Bytes, erase size 64 KiB, total 16 MiB
ubi0: attaching mtd2
ubi0 error: scan_peb: bad image sequence number 968073679 in PEB 124, expected 858837755
Erase counter header dump:
magic 0x55424923
version 1
ec 1
vid_hdr_offset 64
data_offset 128
image_seq 968073679
hdr_crc 0x5c0e5e7f
erase counter header hexdump:
00000000: 55 42 49 23 01 00 00 00 00 00 00 00 00 00 00 01 00 00 00 40 00 00 00 80 39 b3 a1 cf 00 00 00 00 UBI#...............@....9.......
00000020: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 5c 0e 5e 7f ............................\.^.
ubi0 error: ubi_attach_mtd_dev: failed to attach mtd2, error -22
UBI error: cannot attach mtd2
UBI error: cannot initialize UBI, error -22
UBI init error 22
Please check, if the correct MTD partition is used (size big enough?)
Error, no UBI device selected!
Error, no UBI device selected!
=> <INTERRUPT>
=>