SmartControl CLI
A command line interface for SmartControl inspired by its communication protocol, currently it ONLY supports zTC1
Usage
usage: zcontrol.exe <command> [<args>]
discover ask device to report itself
adopt send local MQTT server information to device
activate activate device by given code, it requires the device has been adopted
monitor monitor device status (power and uptime)
switch switch a specific plug on/off
upgrade upgrade device to a certain firmware
Discover
Broadcast a UDP request to the whole local area network and wait for device to report
$ zcontrol.exe discover
ideally it would get a feedback like
Device found! Type: zTC1, Name: zTC1_e10d, Mac: 11111111e10d, IP: 10.0.0.123
Adopt
Adopt device by setting MQTT broker/port/username/password via UDP as MQTT is more reliable than UDP
$ zcontrol.exe adopt -mac 11111111e10d -uri 10.0.0.124 -port 1883 -username admin -password admin
Activate
Activate device by sending activation key, if MQTT server is not provided or not available, it would try to use UDP instead
$ zcontrol.exe activate -code 1234567890abcdefghijklmnopqrstuv -mac 11111111e10d -uri 10.0.0.124 -port 1883 -username admin -password admin
Monitor
Monitor device status/power information
power
$ zcontrol.exe monitor -mac 11111111e10d -monitor power -uri 10.0.0.124
ideally it would response
Power: 5W, Uptime: 42 seconds
Power: 10W, Uptime: 47 seconds
...
state
$ zcontrol.exe monitor -mac 11111111e10d -monitor state -uri 10.0.0.124
ideally it would response
Plug 0: true
Plug 1: true
Plug 2: true
Plug 3: true
Plug 4: true
Plug 5: true
Switch
Control each plug switch on/off status, if MQTT server is not provided or not available, it would try to use UDP instead
- Switch plug 0 on
$ zcontrol.exe switch -mac 11111111e10d -plug 0 -on -uri 10.0.0.124 - Switch plug 2 off
$ zcontrol.exe switch -mac 11111111e10d -plug 2
Schedule is not yet supported
Upgrade
Upgrade device via OTA
$ zcontrol.exe -mac 11111111e10d -ota http://192.168.43.119/TC1_MK3031_moc.ota.bin -uri 10.0.0.124