Ancient Data Prune is a new feature in bsc v1.1.8
MD5 checksum: f4575eb00c785c811353a5736896d713
Special thanks to BNB48Club on contributing another dump of snapshot, you can also refer here to download.
Step 1: Preparation
- Make sure your hardware meets the suggested requirement.
- A disk with enough free storage, at least twice the size of the snapshot.
Step 2: Download && Uncompress
- Copy the above snapshot URL.
- Download:
wget -O geth.tar.lz4 "<paste snapshot URL here>"
. It will take one or two hours to download the snapshot, you can put it in the backgroud bynohup wget -O geth.tar.gz "<paste snapshot URL here?" &
If you need to speedup download, just use aria2c
aria2c -o geth.tar.lz4 -s14 -x14 -k100M https://download.bsc-snapshot.workers.dev/{filename} -o geth.tar.lz4
- Uncompress:
tar -I lz4 -xvf geth.tar.lz4
. It will take more than two hours to uncompress. You can put it in the backgroud bynohup tar -I lz4 -xvf geth.tar.lz4 &
- You can combine the above steps by running a script:
wget -O geth.tar.lz4 "<paste snapshot URL here>"
tar -I lz4 -xvf geth.tar.lz4
- If you do not need to store the archive for use with other nodes, you may also extract it while downloading to save time and disk space:
wget -q -O - <snapshot URL> | tar -I lz4 -xvf -
Step 3: Replace Data
- First, stop the running bsc client if you have one by
kill {pid}
, and make sure the client has shut down. - Consider backing up the original data:
mv ${BSC_DataDir}/geth/chaindata ${BSC_DataDir}/geth/chaindata_backup; mv ${BSC_DataDir}/geth/triecache ${BSC_DataDir}/geth/triecache_backup
- Replace the data:
mv server/data-seed/geth/chaindata ${BSC_DataDir}/geth/chaindata; mv server/data-seed/geth/triecache ${BSC_DataDir}/geth/triecache
- Start the bsc client again and check the logs
erigon version v2.32.0
Step 1: Preparation
- Make sure your hardware meets the suggested requirement.
- BSC Archive: 7TB. BSC Full: 1TB.
Step 2: Download && Uncompress
sudo yum install aria2c
aria2c -s14 -x14 -k100M https://download.bsc-snapshot.workers.dev/{filename} -o erigon.tar.lz4
tar -I lz4 -xvf {filename}
Step 3: Replace Data And Restart erigon
- Stop the running erigon client by
kill {pid}
- Backing up the original data:
mv ${erigon_datadir}/erigon ${erigon_datadir}/erigon_back
- Replace the data:
mv ${erigon_snapshot_dir}/erigon ${erigon_datadir}
- Start the erigon client again and check logs
./build/bin/erigon --chain bsc --db.pagesize=16k --datadir=${erigon_dir/data}