smolkov / irrigatron

Irrigatron

irrigatron

• Name: Irrigatron
• Titul: Der Herr des Wasser und und die Pumpe

🚧 Work In Progress 🚧

🎙️ Commands

• 🦀⚙️ phatsys

  run driver and wath socket for connections. All of the arguments and flags to this command are optional:

  Build your project. This command wath link to `ndir1` directory
  with the `"type"` declared there.
  

• 🔧 irrigatron

  - `range`: defaults to `start:0.0, end: 1.0`
  - `bautrate`: default `57600`
  - `uart`:  defaults to `1` and iterate in `1..4`
  

  Configure sensor for user.

  irrigatron config --uart=2 --path=`test1`
  

• 🔬 🕵️‍♀️ check: run this command to confirm that your configuration is appropriately set up.

🔩 Configuration

init initialize directory.

Building

1. Install cargo:

   Edinburgh is installed through Cargo, a Rust package manager. Rustup, a tool for installing Rust, will also install Cargo. On Linux and macOS systems, rustup can be installed as follows:

   curl https://sh.rustup.rs -sSf | sh
   

   Additional installation methods are available here.

2. Install on linux:

• i686

  Step 1: Install the C cross toolchain

    sudo apt-get install -qq gcc-multilib-i686-linux-gnu

• arm

  Step 1: Install the C cross toolchain

    sudo apt-get install -qq gcc-arm-linux-gnueabihf

  Additional installation methods are available here. Be sure to switch back to stable with rustup default stable if that's your preferred toolchain.

  To cross-compile for the PanelPC you will need an i686-unknown-linux-gnu GCC toolchain and Rust component installed. Add the Rust target with rustup target add i686-unknown-linux-gnu. Then you can cross-compile with cargo:

      cargo build --release --target i686-unknown-linux-gnu
  

  or arm:

      cargo build --release --target arm-unknown-linux-gnueabihf
  
  
  

To cross-compile for the Raspberry Pi you will need an arm-unknown-linux-gnueabihf GCC toolchain and Rust component installed. On Arch Linux I built [arm-linux-gnueabihf-gcc] from the AUR. Add the Rust target with rustup target add arm-unknown-linux-gnueabihf. Then you can cross-compile with cargo:

After it is built copy target/arm-unknown-linux-gnueabihf/release/lca2019 to the Raspberry Pi.

Running

View the options with ./lca2019 -h. By default it will try to bind the webserver to port 80. You can give a regular user the permission to do this with:

sudo setcap cap_net_bind_service=ep lca2019

Alternatively use -p to set the port to a non-privileged one.

Systemd Service

Copy irrigatron.service to /etc/systemd/system/.

sudo systemctl daemon-reload
sudo setcap cap_net_bind_service=ep lca2019
sudo systemctl enable --now lca2019