For new versions, please go to rak_common_for_gateway
based on the latest SX1301 driver lora_gateway v5.0.1 and semtech packet_forwarder v4.0.1
Note: This project is only used for USB interface of RAK833 + Raspberry Pi, if you want to use SPI interface of RAK833 + Raspberry Pi, please use this project: https://github.com/RAKWireless/RAK2245-RAK831-LoRaGateway-RPi-Raspbian-OS. But you should notice the reset GPIO pin definition which is the value of SX1301_RESET_BCM_PIN macro in the start.sh file, it is pin17 now, and you can modify this value according to your hardware.
This project currently provides support for the below platforms.
- RAK833/RAK2247
2019-06-18 RAK V2.8
- 1.Add eth0 config
- 2.After the network is disconnected, lora_pkt_fwd restarts
- 3.Modify loraserver.toml for us915 and cn 470
- 4.Streamlined local_conf.json files
2019-05-06 RAK V2.1R
- Add loraserver
- Add AP mode
step1 : Download and install Raspbian Stretch LITE
step2 : Clone the installer and start the installation
$ git clone https://github.com/RAKWireless/RAK833-LoRaGateway-RPi.git ~/rak833-loragateway
$ cd ~/rak833-loragateway
$ sudo ./install.sh
step3 : Now you have a running gateway after restart! in additon you can check the log info at /var/log/syslog.