Shmyglev Dmitry's repositories
auto_close_window
This IOT project allows you to open and close your window from any smart house. For example - you can setup rules like a "If night and noise greater then expected -> close window" and "Noise reduced -> open window"
climate_control_sensor
Firmware for a climate control device/sensor, based on ESP32 DevKit board
3dprinter_control
Smart house integration with 3D printer. WIFI and camera interface to your printer. Auto power down when printer finished.
air-detector
Air status sensor with hass integration and fan control
atmega_esp32_logger
This firmware allows to read stdout from ATMega microcontroller without JTAG interface
crate-driver
Metabase driver for CrateDB. Community-supported.
Ender3V2
This is optimized firmware for Ender3 V2/S1 3D printers.
hass_pik_intercom
Базовая поддержка домофона ПИК в HomeAssistant
ir_decoder
IR Decoder for climate control sensor.
pantry_signal_system
This project contains schematics and firmware for controlling patry, garage, etc. Its including flooding sensor, auto air dryer and signal system. It connected to smart house using LoRa channel