ESP32Badge
Source code and resources for the ESP32 Conference Badge
Requires the ESP32 conference badge or similar hardware:
- PCB: https://www.pcbway.com/project/shareproject/ESP32_Conference_Badge_v1_2.html
- ESP32 DEVKIT v1 w/30 pins or DevKitC w/38 pins (other ESP32 boards can be used with minimal PIN changes)
- ILI9341 320x240 TFT
- [8] Tactile momentary buttons
- [4] 4k7 resistors (button pullups)
- [3] 5mm LEDs (one each of red, yellow, green)
- [3] 100R resistors (LED current limiters)
- small speaker/active buzzer (8 Ohm / 2 Watt)
- CR18650 battery and battery holder are optional
- Some sketches have additional hardware requirements (components attached to I2C or Serial pins, or SD card)
- PCB is available at PCB Way for order: https://www.pcbway.com/project/shareproject/ESP32_Conference_Badge_v1_2.html
Required Libraries for Arduino platform sketches:
- Adafruit GFX
- Adafruit ILI9341
- ArduinoJson
- XTronical XT_DAC https://www.xtronical.com/the-dacaudio-library-download-and-installation/
Example Sketches:
- Basic: 4 Simple badges combined into one (Marquee, Hello, Hello w/changing message, Gangster wanted poster)
- Framework Only: Starter sketch with only pin defines, component setup, and button checking.
- Gravitack: Low-gravity lunar lander type game
- QR Code: Name badge with QR code display of the ESP32 IP address and simple web page for controlling the LEDs
- Slideshow: Timed slideshow display. Requires v1.2 of the badge with 38-pin DevKitC and an SD card.
- Test1: Test app to verify functionality of the badge. Also available for the ESP-IDF platform.
- Test BLE Peripheral/Central: Shows how to use one badge to control another over BLE.
- Time & Weather: Displays time and weather data from DS3231 RTC and BME280 temperature/humidity/pressure sensor via I2C as well as network weather info
- Tombstone: Classic Morg-shooting schooner game
- Wizard: Animated badge for wizards and witches that have escaped from notorious magical prisons
Accessories:
- Kickstand: Minimalist 3D-printed kickstand for the badge to get it to stand upright on a flat surface. Attach to the middle holes on badge (just below the buttons) with 2 small flat-headed woodscrews.
Scripts:
- img-rgb565.py: convert graphics files to RGB565 bitmap integer array C header files
- wav-pcm8.py: convert 8 bit mono PCM wave files to byte array C header files
Additional Info:
- The TFT display orientation is rotated 180 degrees between the v1.1 /DevKitv1 board and v1.2 DEVKITC versions. Adjust the SCREEN_ROT value in esp32_badge.h to 1 for v1.1 or 3 for v1.2 boards.
- SD card slot on the TFT is not connected in v1.1