/* * A simple shell with pipes * Written by Matt Goldman * Rutgers University 198:416:04 * Last updated 2015-03-22 * * README */ This simple shell can run any external command with I/O piping between them. It has cd and exit built in, and uses a table of function pointers to run them. The input line is parsed into whitespace-separated and quote-wrapped tokens with my lntok() function, which functions similarly to strtok(). The tokens from the string are placed into command_t structs, which assemble into a linked list of commands. When a pipe is detected in the input line, the prior command is ended and a new command is added to the list. Then, the commands are executed by iterating through the linked list and forking a new child for each command. Each command_t struct contains a pipe array which is used for the input of the command (except for the first command in the list). Each command is set to send its output to the pipe in the next command_t struct in the list, and the command in that command_t struct will read from that pipe. The final command in the list has no next command, and so will send its output to stdout. The parent process will also close both ends of the pipe, to ensure that children will terminate. Each child process is replaced by the command in its command_t struct with execvp(), and the parent waits for each to finish executing before displaying a new prompt. Built-in commands are handled with a lookup table consising of structs matching names to functions. Before the commands are executed, the command name is checked against the list of built-in functions. If the function is a built-in, normal exeuction is aborted, and the appropriate function is called from the table. The shell was tested with all the test cases listed at http://www.cs.rutgers.edu/~pxk/416/hw/a-5-test.html