KISSLoRaTNC
Arduino based LoRa KISS TNC
Currently, build is failing for MoteinoMEGA boards due to an out-of-date pin definition in platformio. See issue #199 in platform/atmelavr
To fix locally, go to ~/.platformio/packages/framework-arduino-avr/variants/moteinomega/pins_arduino.h
Add in this line at line #72:
#define digitalPinToInterrupt(p) ((p) == 10? 0: (p) == 11? 1: (p) == 2? 2: NOT_AN_INTERRUPT)
Uncomment the last block in platformio.ini and then build again.
KISSLoRaTNC is a work derived from code written by Sandeep Mistry and Mark Qvist
This code was developed using VSCode and Platformio.
KISSLoRaTNC is developed for the:
- Arduino Uno, using the HamShield: LoRa Edition
- Arduino Micro, using the Adafruit RFM96W LoRa Radio Breakout
- MoteinoMEGA-USB with the RFM96 Transceiver
- Arduino Nano, using the Adafruit RFM96W LoRa Radio Breakout
- Heltec WiFi LoRa 32 (V2) Note: should work with other ESP32 LoRa boards that use the same SPI pins
The Config.h file contains the pinouts for the different Arduino-based boards. These pinouts are specific to the microcontroller board and LoRa device pairings in the list above. If you decide to use a different pairing, please adjust Config.h accordingly. Also, please remember that the power output should also be adjusted, as the RFM96W has a max Tx Power value of 20dBm. The HamShield: LoRa Edition 440MHz can be set to 30dBm (1 watt).
"Default" settings are:
- Frequency: 434.450 MHz
- Spreading Factor: 8
- Coding Rate: 7
- Signal Bandwidth: 125 kHz
- Tx Power: 20 (can be set to 30 for HamShield)
- Serial: 38400, 8N1
Basically, after checking the Config.h file for correctness, build and upload to your Arduino-based board.
The KISS SetHardware (0x06) command supports the follow options:
| Option | Data | Description |
|---|---|---|
| 0x22 | uint8_t | LoRa Spreading Factor (6 - 12) |
| 0x23 | uint8_t | LoRa Coding Rate (5 - 8) |
| 0x24 | uint32_t | LoRa Bandwidth (MSB first) |
| 0x25 | uint8_t | Transmit Power (0 - 20 dBm) |
| 0x26 | uint32_t | Frequency (MSB first) |
| 0x27 | none | Save hardware parameters in EEPROM |
| 0x28 | none | Restore hardware parameters from EEPROM |
The following examples show what the KISS packet would be (in hex bytes):
To set a Spreading Factor of 12: 0xC0 0x06 0x22 0x0C 0xC0
To set a frequency of 433.775 MHz: 0xC0 0x06 0x25 0x19 0xDA 0xE1 0x98 0xC0
To save hardware parameters in EEPROM: 0xC0 0x06 0x27 0xC0
Note: Follow proper KISS byte escaping if FEND (0xC0) or FESC (0xDB) appear in the data
For details on the KISS protocol, please refer to The KISS TNC: A simple Host-to-TNC communications protocol
Useful applications: