Firmware and code for building an Orthoverse T-Display-S3 display device. Note that this repository also provides general information for anyone wanting to code in micropython for the Lilygo T-Display-S3 and then compile and flash functioning firmware to the device.
Almost all the information to do this was available on the Internet, but it was scattered all over the place, and a few key pieces were missing.
I aim to make my repositories as understandable as possible, so if you find yourself confused please open an issue explaining your problem and I'll try to resolve it.
Ensure you have the latest packages and everything is up to date:
apt-get -y update
apt-get -y upgrade
Install the required packages
apt-get -y install build-essential libffi-dev git pkg-config cmake virtualenv python3-pip python3-virtualenv python3-libusb1
Then run ./setup.sh to clone and install all required repositories
Build firmware with ./build.sh
Please note that I like my repositories to document the journey, rather than just the end result.
One approach is to start a Ubuntu docker container, and run the setup.sh script to configure it correctly, although this takes quite some time if you want to run the container again and again. It is, however, a useful tutorial.
-
Install docker if you don't have it already. See the docker install guide
-
Run the following command from this repository's main folder to start an interactive bash terminal, with the current folder mapped to /orthoverse-s3:
docker run -v "$(pwd)":/orthoverse-s3/ -it ubuntu:22.04 /bin/bash
- Change to the mapping of this repository:
cd /orthvoerse-s3/
- Run the setup script, which should clone and build all the required tools for you:
./setup.sh
A better long-term solution is to build an image that is configured correctly to make board builds correctly.
docker build -f Dockerfile -t s3lcd-build --compress .
Once you have the build image, you can start it immediately using:
docker run -it s3lcd-build
To make a build, run c./build.sh
TODO: add instruction to map firmware folder and modules folder to local machine.
The instructions for flashing the firmware.bin file to your device are here