📋 Please see the Changelog for possible important information !
This script acts as a helping hand for you to get set up in a fast and comfortable way.
This does not mean, it will relieve you of using your brain.exe! 🧠
Please also always pay attention to the individual component repositories (all linked below).
Feel free to give it a try. If you have suggestions or encounter any problems, please report them.
For downloading this script it is necessary to have git installed.
If you haven't, please run sudo apt-get install git -y to install git first.
You will need it anyways! 😄
After git is installed, use the following commands in the given order to download and execute the script:
cd ~
git clone https://github.com/th33xitus/kiauh.git
./kiauh/kiauh.sh- New in v3.0.0: You can now install multiple instances (Klipper/Moonraker/DWC/Octoprint) on the same Pi!
- Installing Klipper to your Raspberry Pi or other Debian based Linux Distribution.
- Installing of the Moonraker API (needed for Mainsail, Fluidd and KlipperScreen)
- Installing several different web interfaces such as Mainsail, Fluidd, Duet Web Control or OctoPrint including their dependencies.
- Installing of KlipperScreen (OctoScreen but for Klipper!)
- Updating of all the listed installations above excluding OctoPrint. For updating OctoPrint, please use the OctoPrint interface!
- Removing of all the listed installations above.
- Backup of all the listed installations above.
- Build the Klipper Firmware
- Flash the MCU
- Read ID of the currently connected MCU
- and more ...
For a list of additional features please see: Feature List
- Tested only on Raspberry Pi OS Lite (Debian 10 Buster)
- Other Debian based distributions can work
- Reported to work on Armbian too
- During the use of this script you might be asked for your sudo password. There are several functions involved which need sudo privileges.
For more information or instructions to the various components KIAUH can install, please check out the corresponding repositories listed below:
⛵Klipper by KevinOConnor :
https://github.com/Klipper3d/klipper
⛵Klipper S-Curve fork by dmbutyugin :
https://github.com/dmbutyugin/klipper/tree/scurve-smoothing
https://github.com/dmbutyugin/klipper/tree/scurve-shaping
🌙Moonraker by Arksine :
https://github.com/Arksine/moonraker
💨Mainsail Webinterface by meteyou :
https://github.com/meteyou/mainsail
🌊Fluidd Webinterface by cadriel :
https://github.com/cadriel/fluidd
🕸️Duet Web Control by Duet3D :
https://github.com/Duet3D/DuetWebControl
🕸️DWC2-for-Klipper-Socket by Stephan3 :
https://github.com/Stephan3/dwc2-for-klipper-socket
🖥️KlipperScreen by jordanruthe :
https://github.com/jordanruthe/KlipperScreen
🐙OctoPrint Webinterface by OctoPrint :
https://octoprint.org
https://github.com/OctoPrint/OctoPrint
🔬PrettyGCode for Klipper by Kragrathea :
https://github.com/Kragrathea/pgcode
🤖Telegram Bot for Moonraker by nlef :
https://github.com/nlef/moonraker-telegram-bot
Q: Can i use this script to install multiple instances of Klipper on the same Pi? (Multisession?)
A: Yes, it is finally possible 🙂