This is a fork of the original ESP32 Arduino core exatly at it's 1.0.0 release. After Version 1.0.6 came IDF 4 and this increased flash size requirements significantly. Nevertheless, some later bugfixes that went into upstream arduino-esp32 have been backported to this fork.
Arduino core for ESP32 WiFi chip
Arduino core for the ESP32
Contents
- Development Status
- Installation Instructions
- Decoding Exceptions
- Issue/Bug report template
- ESP32Dev Board PINMAP
Development Status
Installation Instructions
- Using Arduino IDE Boards Manager (preferred)
- Using Arduino IDE with the development repository
- Using PlatformIO
- Building with make
- Using as ESP-IDF component
- Using OTAWebUpdater
Decoding exceptions
You can use EspExceptionDecoder to get meaningful call trace.
Issue/Bug report template
Before reporting an issue, make sure you've searched for similar one that was already created. Also make sure to go through all the issues labelled as for reference.
Finally, if you are sure no one else had the issue, follow the ISSUE_TEMPLATE while reporting any issue.
ESP32Dev Board PINMAP
Tip
Sometimes to program ESP32 via serial you must keep GPIO0 LOW during the programming process