puchongcnxx29 / esphome-xiaomi_bslamp2

ESPHome integration for the Xiaomi Mijia Bedside Lamp v2.

ESPHome components for Xiaomi Mijia Bedside Lamp 2

[ Changelog | License | Code of conduct ]

The Bedside Lamp 2 is a smart RGBWW LED lamp, produced by Yeelight. It can be controlled via the WiFi network and using a touch panel on the front of the device. The touch panel contains a power button, a button that changes the color of the light and a slider that can be used to change the brightness of the light.

This project provides custom components for ESPHome, which make it possible to fully control every aspect of the lamp and to integrate the lamp in your Home Assistant setup.

Features

• The lamp integrates easily with Home Assistant using the ESPHome integration.

• The lamp no longer phones home to the Mijia Cloud. Using this firmware, you can rest assured that the network traffic is limited to your own network. This matches the ideas behind Home Assistant, of providing a local home automation platform, that puts privacy first.

• No more need for the LAN control option to integrate the lamp with Home Assistant. Especially important, because Xiaomi decided in all their wisdom to remove LAN control from the device, breaking existing integrations.

• The night light supports multiple colors. The original firmware only supports a single warm white night light color.

• Smooth light color transitions, unlike the current version of the Yeelight integration. The Homekit integration does provide good transitions, but on my system, the color temperature white light mode is missing in the Home Assistant GUI.

• Since the components of the lamp are exposed as ESPHome components, you don't have to stick with the lamp's original behavior. You can hook up the lamp in your home automation as you see fit. Use the slider to control the volume of your audio set? Long press the power button to put your house in night mode? Use the illumination behind the slider bar to represent the progress of your sour dough bread bulk fermentation? Go ahead, make it so! :-)

• Possibilities to extend the device's functionality through hardware mods. There are GPIO pins that are not in use. If "tinkerer" is your middle name, you can use those pins to come up with your own hardware hacks to extend the device's functionality.

Quick start guide

For those who have experience with flashing ESPHome onto devices:

• Clone the GitHub repo into your ESPHome config/custom_components directory.
• Copy [doc/example.yaml](doc/example.yaml) to config/your_device_name.yaml.
• Modify the configuration to your needs (see the configuration guide).
• Compile the firmware.bin file and download it to the device to which you have connected your serial to USB adapter (FTDI).
• Open up the lamp and connect its TX, RX, GND and GPIO0 debug pads to the serial adapter. Check this image for the debug pad locations.
• Power up the lamp with GPIO0 connected to GND to enable flashing mode.
• Flash firmware.bin onto the device.

If you experience regular disconnects between Home Assistant and the lamp, then take a look at the known issues document.

Table of contents

• Why custom firmware?
• Installation guide
• Configuration_guide
• Flashing guide
• Known issues
• Technical details
• Sponsoring