Arduino SIM800L library

A smart HTTP library based on Seeeduino that implements the AT HTTP commands to perform GET and POST requests to a JSON API.

Support

Your board have to support the standard SoftwareSerial library. It doesn't work with HardwareSerial based boards for the moment.
The API response have to be a valid JSON.
The library has been tested again Arduino Uno and Arduino Nano

Instalation

Download the library and then import it.

Quick start!

Here's some code to perform a GET request! 👍

unsigned int RX_PIN = 7;
unsigned int TX_PIN = 8;
unsigned int RST_PIN = 12;
HTTP http(9600, RX_PIN, TX_PIN, RST_PIN);
http.configureBearer("your.mobile.service.provider.apn");
http.connect();

char response[256];
Result result = http.get("your.api.com", response);

Serial.println(response);

http.disconnect();

Here's some code to perform a POST request! 👍

unsigned int RX_PIN = 7;
unsigned int TX_PIN = 8;
unsigned int RST_PIN = 12;
HTTP http(9600, RX_PIN, TX_PIN, RST_PIN);
http.configureBearer("your.mobile.service.provider.apn");
http.connect();

char response[256];
Result result = http.post("your.api.com", "{\"date\":\"12345678\"}", response);

Serial.println(response);

http.disconnect();

I suggest the ArduinoJSON library for parsing the JSON response, then you can play with the values easily.

How it works?

In order to perform a request, the library follows these steps:

Configure Bearer:

AT+CREG? -> try until 0,1 (connected to the network)
AT+SAPBR=3,1,"Contype","GPRS" -> wait for OK
AT+SAPBR=3,1,"APN","movistar.es" -> wait for OK
AT+SAPBR=1,1 -> wait for OK

HTTP GET:

AT+HTTPINIT -> wait for OK
AT+HTTPPARA="CID",1 -> wait for OK
AT+HTTPPARA="URL","your.api.com"-> wait for OK
AT+HTTPSSL=0 -> wait for OK (1 when URL starts with "https://")
AT+HTTPACTION=0 -> wait for 200
AT+HTTPREAD -> read buffer and parse it
AT+HTTPTERM -> wait for OK
AT+SAPBR=0,1

HTTP POST:

AT+HTTPINIT -> wait for OK
AT+HTTPPARA="CID",1 -> wait for OK
AT+HTTPPARA="URL","your.api.com" -> wait for OK

For example, if we have this body: {"location_id": 238, "fill_percent": 90}

AT+HTTPPARA="CONTENT","application/json"
AT+HTTPDATA=strlen(body),10000 -> wait for DOWNLOAD, then write the body and wait 10000
AT+HTTPSSL=0 -> wait for OK (1 when URL starts with "https://")
AT+HTTPACTION=1 -> wait for ,200,
AT+HTTPREAD -> read buffer and parse it
AT+HTTPTERM -> wait for OK
AT+SAPBR=0,1

Future improvements

Support of HardwareSerial.
Support of more content types, not only JSON (application/json).

pietrodizinno / ArduinoSIM800L