Toy Robot Simulator

Installation

bundle install

ruby main.rb

rspec

The application is a simulation of a toy robot moving on a square tabletop, of dimensions 5 units x 5 units
There are no other obstructions on the table surface
The robot is free to roam around the surface of the table, but must be prevented from falling to destruction. Any movement that would result in the robot falling from the table must be prevented, however further valid movement commands must still be allowed
You need to provide test data/results for the app & its logic

Create an application that can read in commands of the following form:
PLACE X,Y,F
MOVE
LEFT
RIGHT
REPORT
PLACE will put the toy robot on the table in position X,Y and facing NORTH, SOUTH, EAST or WEST
The origin (0,0) can be considered to be the SOUTH WEST most corner
The first valid command to the robot is a PLACE command, afer that, any sequence of commands may be issued, in any order, including another PLACE command
The application should discard all commands in the sequence until a valid PLACE command has been executed
MOVE will move the toy robot one unit forward in the direction it is currently facing
LEFT and RIGHT will rotate the robot 90 degrees in the specified direction without changing the position of the robot
REPORT will announce the X,Y and F of the robot. This can be in any form, but standard output is sufficient
Input can be from a file, or from standard input, as the developer chooses
Provide test data to exercise the application

The toy robot must not fall off the table during movement. This also includes the initial placement of the toy robot
Any move that would cause the robot to fall must be ignored

Output: 0,1,NORTH

Output: 0,0,WEST

Output: 3,3,NORTH