osfreak / tgFX

A GUI controller for the TinyG motion controller.

tgFX - A TinyG GUI

A JavaFX 2 based GUI controller for the TinyG motion controller.

This code is under heavy development. '''Use this code at your own RISK!''' Please note that tgFX is NOT backwards compatible with firmware older tinyg firmware versions. tgFX will notify you if your TinyG firmware is too old.

Getting Started

Current binary builds for Windows and OSX (linux has not be fully tested) are avilable here: https://www.dropbox.com/sh/huiupgemipv8f4q/X2l_1EH-gx

Installing

Installing tgFX is very easy. All you have to do is go down to the Binary Download section below and follow the dropbox link.
NOTE: OSX USERS Please note that if you are using the OSX binary please read the instructions here: https://github.com/synthetos/tgFX/wiki/Troubleshooting#cannot-connect-to-serial-port----osx

Binary Downloads

For those that want to test out tgFX on their TinyG the latest binaries will be located here : https://www.dropbox.com/sh/huiupgemipv8f4q/X2l_1EH-gx
If you find bugs please open an issue here: https://github.com/synthetos/tgFX/issues?direction=desc&sort=created&state=open

Developers, Developers, Developers, Developers.... :)

If you would like to setup your development enviroment for Mac we have a wiki page here. https://github.com/synthetos/tgFX/wiki/Developer-Notes

Thanks and remember that tgFX is still in beta. Try running a job with the motors inhibited before attempting to cut.