open-sdr / openwifi

open-source IEEE 802.11 WiFi baseband FPGA (chip) design: driver, software

Repository from Github https://github.comopen-sdr/openwifi

open-sdr/openwifi Issues

Can you tell me how to find the matlab code for the openwifi hardware and how to make it work in 802.11b mode?
Updated 6 months ago
请问如何找到openwifi硬件对于的matlab代码以及如何让其工作在802.11b的模式
Updated 6 months ago1
Putting RX antennta decreases injection data rate on monitor mode
Updated 6 months ago
Unable to find main.c program
Updated 6 months ago
Running wgd.sh completely hangs the system (zc702_fmcs2)
Updated 6 months ago
Change any frequency
Updated 6 months ago2
Assistance with Running OFDM Project on ZCU102 + FMCOMMS3 in Vitis
Updated 6 months ago1
hostapd: no process found (zed_fmcs2)
Updated 6 months ago1
Uboot
Updated 7 months ago
Modifying the bandwidth can impact the stability of work
Updated 7 months ago2
Software timestamp
Updated 10 months ago
Unable to send frame
Updated 10 months ago1
Inquiry on OpenWiFi Signal Range
Updated 10 months ago
Questions for acceptance frequency
Updated 10 months ago
Question for CSI
Updated a year ago1
Idea: TCM extension to wifi
Updated a year ago1
Authentication timeout when connecting with wpa_supplicant
Updated a year ago
problems in Let openwifi work at arbitrary frequency
Updated a year ago1
Porting openwifi to other boards
Updated a year ago1
rssi correction
Updated a year ago2
Why can't openwifi work in lower frequency? such as 1.6/1.5/1.4 G…
Updated a year ago2
If I am unable to modify the default gateway of the router to 192.168.10. *, how should I handle it
Closed a year ago
Sensitivity
Updated a year ago1
Sensitivity
Closed a year ago
viterbi_v7_0 IP license not found.
Updated a year ago
SD card image download links "Not Found"
Updated a year ago
MCS problem
Closed a year ago4
is:issue is:open May I ask how to change the RF power of OpenWiFi? The current board used is Antsdr, and I want to increase the RF power to improve communication quality and distance
Closed a year ago
How to output a fixed RF frequency with openwifi
Closed a year ago
Support for another RF frontend card
Closed a year ago
Issues Identified in OpenWiFi Scripts for Mesh Functionalit
Closed a year ago
adrv9361z7035 can't connect 'openwifi'
Closed a year ago
XC7Z015 support?
Closed a year ago
[Feature request] Support of SoapySDR as a neutral and platform independent SDR support library
Closed a year ago8
extracting CSI results from two RX antennas
Updated a year ago2
Error reporting about CSI radar
Closed a year ago5
How to extracting CSI results from two RX antennas for the phase difference
Updated a year ago2
Cannot find the E310v2 kernel in BOOT/openwifi/ after burning the SD card
Closed a year ago5
Instability in CSI Data Obtained by OpenWiFi When Monitoring Mobile Phone WiFi Signals in a Stable Environment
Updated a year ago6
How to use packet-iq-self-loopback-test
Updated a year ago1
In the IQ capture experiment, running ./monitor_ch.sh will change the master of sdr0, causing the phone connection to disconnect.
Closed a year ago
ADRV9361Z7035 reports wrong amount of available memory
Updated a year ago1
CSI Phase keeps changing Despite relatively stable environment
Closed a year ago7
Some questions about clock tree
Updated a year ago
enable 802.11p
Updated a year ago7
输出功率
Closed a year ago
capturing CSI for 2 antenas
Closed a year ago4
Problems with the data in the side_info.txt file that records CSI information.
Closed a year ago
Actual outcome >0.6 ms delay ping time not as shown as short in openwifi introduction.
Updated 2 years ago2
sdr0: AP-ENABLED but could not find "openwifi" on phones and computers as 'quick start' on zcu102.
Closed 2 years ago