Python3 only.
Currently supported devices are (as they show up in thermaltakes TTRGBPLUS software:
Flow Riing RGB
Lumi Plus LED Strip
Pacific PR22-D5 Plus
Pacific Rad Plus LED Panel
Pacific V-GTX 1080Ti Plus GPU Waterblock
Pacific W4 Plus CPU Waterblock
Riing Plus
If your's isn't listed, please create an issue and I'll implement it ASAP!!
sudo pip3 install linux_thermaltake_rgb
The setup file will create the systemd user unit, and udev rule
in /usr/share/linux_thermaltake_rgb
you will need to copy these to the appropriate locations:
sudo cp /usr/share/linux_thermaltake_rgb/90-linux_thermaltake_rgb.rules /etc/udev/rules.d/
sudo cp /usr/share/linux_thermaltake_rgb/linux-thermaltake-rgb.service /usr/lib/systemd/user/
# and if this is a fresh install copy the default config file:
sudo mkdir /etc/linux_thermaltake_rgb/
sudo cp /usr/share/linux_thermaltake_rgb/config.yml /etc/linux_thermaltake_rgb/then add your user to the plugdev group - sudo usermod -a -G plugdev $USER
then reconnect your device.
note: you may need to log out and back in so your user is recognised as being in the plugdev group
available in the aur as linux-thermaltake-rgb
start and enable the systemd service
systemctl --user start linux-thermaltake-rgb.service; systemctl --user enable linux-thermaltake-rgb.service
the configuration file is expected to be in: /etc/linux_thermaltake_rgb/config.yml
edit and configure suitably.
example config is in linux_thermaltake_rgb/assets/config.yml