cdk-vpc-template
AWS CDK application written in Python for a VPC. Parameterized to be customizable.
Introduction
This AWS CDK application deploys a VPC with 2 availability zones with one public and one private subnet per availability zone. The following diagram describes the structure.
One NAT Gateway is created per availability zone to allow for outbound internet traffic from the private subnets.
Prerequisites
The following lists the required prerequisites for this application:
- AWS Account
- cdk (instructions here)
- Python 3.7 or above
In addition, command line access to the AWS account should be configured. Commandline access must be enabled and an access key to be available. This can be enabled through the AWS console.
Once that is set up, download awscli and configure access by running
aws configure
and following the prompts.
Installation
Run the following to create a Python virtual environment.
python3 -m venv .venv
Then, activate the environment with the following (on Mac or Linux).
source .venv/bin/activate
Then, install the Python packages with the following.
pip3 install -r requirements.txt
To install the test dependencies and run tests, run the following two commands.
pip3 install -r requirements-dev.txt
pytest .
Deployment
To deploy the application, cdk must first be bootstraped for the region in the AWS account. To do so, run the following.
cdk bootstrap
Then, run the following from the root directory of the application with the Python virtual environment activated.
cdk deploy \
--context account=<ACCOUNT ID> \
--context region=<REGION>
Replace <ACCOUNT ID> and <REGION> with the appropriate parameters.