Product(PinMap) | SOC | Flash | PSRAM | Resolution |
---|---|---|---|---|
T-Display-S3-Long | ESP32-S3R8 | 16MB | 8MB(OPI) | 180x640 |
Current consumption | Working current | sleep current | sleep mode |
---|---|---|---|
T-Display-S3-Long | (240MHz) WiFi On 90~350+ mA | About 1.1mA | gpio wakeup |
examples/
├── Factory # Factory example
├── tft # Tft example
├── touch # Touchpad example
├── QWIIC_Sensor # QWIIC Wire example
└── lvgl_demo # LVGL examples
- Install Visual Studio Code and Python
- Search for the
PlatformIO
plugin in theVisualStudioCode
extension and install it. - After the installation is complete, you need to restart
VisualStudioCode
- After restarting
VisualStudioCode
, selectFile
in the upper left corner ofVisualStudioCode
->Open Folder
-> select theT-Display-S3-Long
directory - Wait for the installation of third-party dependent libraries to complete
- Click on the
platformio.ini
file, and in theplatformio
column - Uncomment one of the lines
src_dir = xxxx
to make sure only one line works - Click the (✔) symbol in the lower left corner to compile
- Connect the board to the computer USB
- Click (→) to upload firmware
- Click (plug symbol) to monitor serial output
- If it cannot be written, or the USB device keeps flashing, please check the FAQ below
- It is recommended to use platformio without cumbersome steps
- Install Arduino IDE
- Download or clone project
T-Display-S3-Long
- Copy all the files in
T-Display-S3-Long/lib
and paste them into Arduion library folder(e.g. C:\Users\YourName\Documents\Arduino\libraries). - Open Arduino IDE, select the
examples\xxx
example of projectT-Display-S3-Long
throught"File->Open"
. - Configuration of board is as follows:
- Select
Port
- Click
upload
, Wait for compilation and writing to complete - If it cannot be written, or the USB device keeps flashing, please check the FAQ below
- BLE Examples
- WiFi Examples
- SPIFFS Examples
- FFat Examples
- For more examples of esp32 chip functions, please refer to arduino-esp32-libraries
-
The board uses USB as the JTAG upload port. When printing serial port information on USB_CDC_ON_BOOT configuration needs to be turned on. If the port cannot be found when uploading the program or the USB has been used for other functions, the port does not appear. Please enter the upload mode manually.
- Connect the board via the USB cable
- Press and hold the BOOT button , While still pressing the BOOT button, press RST
- Release the RST
- Release the BOOT button
- Upload sketch
-
If the above is invalid, burn the binary file to check whether the hardware is normal
Do not upgrade the LVGL version, the lvgl software rotation has been forced to open.