mcauser / microbit-am2320

MicroPython for micro:bit library for the Aosong AM2320 temperature and humidity sensor

BBC micro:bit MicroPython AM2320 I2C

A micro:bit MicroPython library for interfacing with an Aosong AM2320 temperature and humidity sensor over I2C.

This library focuses on using the I2C interface. The sensor also supports a 1-wire interface, available when pin 4 is connected to GND.

Examples

In these examples, I am using pins 13 and 15 for I2C clock and data, however, you can use any pin. Pins 13 and 15 are normally used for SPI. My Kitronik edge connector breakout board does not have pin headers soldered for the standard I2C pins 19 and 20 (where you can find the accelerometer and compass), otherwise I'd be using them.

Basic measurement

from microbit import *
import am2320

i2c.init(sda=pin15, scl=pin13)
sensor = am2320.AM2320(i2c)

sensor.measure()
print(sensor.temperature())
print(sensor.humidity())

Press Button A to measure, Button B to exit

from microbit import *
import am2320

i2c.init(sda=pin15, scl=pin13)
sensor = am2320.AM2320(i2c)

while True:
	if button_a.is_pressed():
		try:
			sensor.measure()
			display.scroll(str(sensor.temperature())+"c", 50)
		except OSError:
			display.scroll("Err")
	if button_b.is_pressed():
		display.scroll("End")
		break

Continuous measurement

from microbit import *
import am2320

i2c.init(sda=pin15, scl=pin13)
sensor = am2320.AM2320(i2c)

while True:
	try:
		sensor.measure()
		print(sensor.temperature())
		print(sensor.humidity())
		sleep(4000)
	except OSError:
		print("Error")
		sleep(1000)

Links

• BBC micro:bit
• MicroPython for the BBC micro:bit
• Kitronik Edge Connector Breakout Board
• micropython.org
• micro:bit on the MicroPython forum
• MicroPython AM2320

License

Licensed under the MIT License.