Qubes OS U2F proxy
This tool is intended to securely forward U2F challenge-response authentication between Web browser and U2F HID token without exposing the browser and USB stack to one another.
This implements FIDO U2F version 1.2 with HID encapsulation. See also non-normative U2F Overview for introduction and U2F threat model.
HOWTO
Requirements
- Qubes R3.2 or later (R4.0 or later recommended)
- For Debian template: Debian 9 (stretch) or later
- For Fedora template: Fedora 25 or later
- Python 3.5
- https://github.com/Yubico/python-u2flib-host
- For building manpages:
python3-sphinx
Installation
The guide assumes there is sys-usb
qube which holds the USB Host PCI device
and the qube which holds the browser (or other U2F client) is named work
.
- In
debian-9
:
sudo apt install qubes-u2f
- In
fedora-25
:
sudo dnf install qubes-u2f
- In
dom0
:
qubes-dom0-update qubes-u2f-dom0
qvm-service --enable work qubes-u2f-proxy
Advanced: per-qube access enforced by policy
This requires Qubes R4.0 or later (as of this writing, available as release candidate).
In dom0
, create a file
/etc/qubes-rpc/policy/policy.RegisterArgument+u2f.Authenticate
with the
following content:
sys-usb $anyvm allow,target=dom0
Then remove /etc/qubes-rpc/policy/u2f.Authenticate
and register your token.
After doing this, any qube will have access only to tokens enrolled using that
particular qube. Also, any previously registered token will not work.
Threat model
Threat model is two-ways, both frontend and backend are untrusted from each others point of view. It is assumed that either side could be taken control of by an attacker: for example the backend domain could have vulnerabilities in USB stack and frontend domain can be taken over via exploit against web browser. It is further assumed that either side is capable of sending arbitrary messages within the constraints of qrexec policy.
The aim of the frontend site would be typically to get unlimited access to token, and possibly key materiel if the token is software-only. The aim of the backend would be to get access to any secrets held in frontend domain, and there certainly are some, since the user is deploying U2F authentication to protect them in the first place. That access should not be possible.
It is explicitly not a goal to ensure any security properties already provided by the U2F protocol itself. It is also not a goal to prevent cooperative channels between the browser and the token.
Architecture diagram
Incompatibilities
WINK does not work, even if the underlying harware token does support it.