ESP3D
ememem13 opened this issue · comments
How to pre-lure ESP3D interface?
Just enable the ESP3D in the file Configuration_adv.h
#define ESP3D_WIFISUPPORT // ESP3D Library WiFi management (https://github.com/luc-github/ESP3DLib)
I get this, no IP address, only the router address is displayed (192.168.0.1):
--- Available filters and text transformations: colorize, debug, default, direct, esp32_exception_decoder, hexlify, log2file, nocontrol, printable, send_on_enter, time
--- More details at http://bit.ly/pio-monitor-filters
20:38:38.917 > f~�start
20:38:39.350 > External Reset
20:38:39.350 > Brown out Reset
20:38:39.351 > Watchdog Reset
20:38:39.352 > Marlin 2.0.9.1
20:38:39.352 >
20:38:39.352 > echo: Last Updated: 2021-06-27 | Author: (none, default config)
20:38:39.356 > echo:Compiled: Oct 6 2021
20:38:39.357 > echo: Free Memory: 296624 PlannerBufferBytes: 1280
20:38:39.365 > echo:EEPROM version mismatch (EEPROM=? Marlin=V84)
20:38:39.368 > echo:Hardcoded Default Settings Loaded
20:38:39.625 > Error:MAXTEMP triggered, system stopped! Heater_ID: bed
20:38:39.628 > echo:Err: MAXTEMP
20:38:39.629 > Error:Printer halted. kill() called!
20:38:39.697 > echo:AP started
20:38:39.698 > echo:192.168.0.1
20:38:39.813 > echo:OTA service started
20:38:39.817 > echo:HTTP server started
the board have started AP servers if it can not connect to local wifi. so you can find the wifi SSID of esp32 and connect to it with browser , then set your local wifi. or you can set the default wifi in the marlin firmware,https://github.com/markniu/PandaZHU/wiki/Compile&Flash-firmware#how-to-set-default-wifi