makerbase-mks / MKS-SERVO42C

MKS SERVO42C, an upgraded version of MKS SERVO42B, built-in Field-Oriented control algorithm, position/speed/ torque closed-loop, 4 Half bridge driver with 8 MOSFET, it makes the motor quieter, lower vibration and Lower calorific.

makerbase-mks/MKS-SERVO42C Issues

firmware source code
Updated a month ago2
Motor miscalculating steps causes excess movement.
Closed 3 months ago5
Servo42c freezes if EN pin is connected to the main board
Updated 2 months ago7
Jerk each full revolution
Updated 3 months ago1
motor loses steps
Updated 3 months ago1
Servo42c problem,
Updated 3 months ago1
The driver keeps enable, and problems with arduino at 24v
Updated 5 months ago1
'Reverse lookup Error' when doing calibeation
Updated 5 months ago1
Firmware needed for study
Updated 5 months ago3
UART communication protocol does not set 256 microsteps as it only uses a byte
Updated 6 months ago1
Sensorless homing feature
Updated 7 months ago2
Querying for angle while motor moving interrupts motion.
Updated 7 months ago1
Problem with UART responses
Closed 8 months ago1
no uart communication
Updated 8 months ago1
Motor jumps forward when enable pin is activated
Updated 9 months ago1
In Serial Uart mode, the command is executed well, but repose is not returned.
Updated 10 months ago
Motor Movement by UART stops on next Command
Updated a year ago5
No firmware
Updated a year ago1
Is there any example code for Arduino?
Updated a year ago3
UART read encoder command 0x30
Updated a year ago1
V1.1. how to release motor after stall protection triggers?
Updated a year ago1
Motor does not stop in time.
Updated a year ago2
Firmware V1.2
Updated a year ago1
MKS-SERVO42C runns only in left direction
Closed a year ago1
Visible VFA on straight wall surfaces
Updated a year ago
Vibration while moving
Updated a year ago
42C V1.1 on Y Axis Creality 42-40
Updated a year ago2
Alarm pin
Updated a year ago
Motor driver burned
Updated a year ago2
Servo42C does not work
Updated a year ago1
STP pin with 24VDC
Updated a year ago1
Encoder value missmatch signal?
Updated a year ago
What function does the led have?
Updated a year ago
v1.1 - when moving slowly, load on the shaft leads to fast spinning
Updated a year ago4
Docs on USART control commands of the stepper
Updated a year ago1
Servo Control Tool is unusable
Updated a year ago1
SERVO42C Drivers will damage themselves when is they accidentally hit an endstop, current limit is not respected
Updated a year ago2
Stepper only moves when dirPin is HIGH
Updated a year ago4
No BOM showing connector part numbers available
Updated 2 years ago
What is the correct connector/header to control the PCB via the software?
Updated 2 years ago2
max speed
Updated 2 years ago1
About the new firmware V1.1
Updated 2 years ago14
FD Command - Error with New User Manual or NEW FIRMWARE?
Updated 2 years ago1
Run by serial command - SPEED
Updated 2 years ago
UART Control - command 34: e0 fd xx xx xx xx xx tCHK The motor run to an angle in a speed - No terminating message
Updated 2 years ago
Extra Characters from UART after command transmission
Updated 2 years ago1
bad translation: welding
Updated 2 years ago
Stall detection
Updated 2 years ago
Schematic of control interface
Closed 2 years ago1
"Wishlist" for next firmware
Updated 2 years ago3