ESPHome firmware for ESPresenceLD sensor (ESP32+LD2410x)
Installing ESPHome on hardware with a minimum of 2GB of RAM (4GB is recommended) is crucial, otherwise it may not be able to compile the firmware properly. The setup process of your Home Assistant can be smoother with Bluetooth enabled, as it autodiscovers, adopts, and compiles the latest firmware available.
Read PDF file in repository --> ESPresence-LD2410-Install.pdf
If you want to bring your device to the initial conditions please follow below steps:
- download the loader firmware from this repository -- espresenceld.bin
- connect your device to PC with USB cable and flash the firmware just downloaded using ESPHome Flasher tool
- Now the device is in the initial condition and you can install it following the instructions
This firmware is suitable for my ESPresence device based on ESP32-WROOM-32D microcontroller and LD2410C presence sensor. You can purchase this device using the link in the next section.
| GPIO | Assigned Function |
|---|---|
| IO18 | LD24x0 TX Pin |
| IO33 | LD24x0 RX Pin |
| IO13 | Status LED (Green) used by ESPHome |
| IO23 | Disable Occupancy LED (Red) |
| IO34 | LDR for analog luminosity reading |
| IO25 | ICS Bus - SCL or SDA Pin |
| IO26 | ICS Bus - SDA or SCL Pin |
NOTE: in I2C_device folder you can find example code for tested I2C sensor; you can simply copy and paste them at the end of the YAML code of your ESPresenceLD device and recompile the firmware.
Link to TINDIE store for purchase: https://www.tindie.com/products/33322/
Link to HACS for custom card (Maurizio Arci): https://github.com/madmicio/lovelace-ld-2410-control-card
Link to THINGIVERSE for STL files (Henrik Sozzi): - TBD -