Serial Peripheral Interface (SPI) is a synchronous serial data protocol used for communication between digital circuits. Therefore with SPI interface FPGAs or microcontrollers can communicate with peripheral devices, sensors and also other FPGAs and microcontrollers quickly over short distances.
In this implementation both SPI master and SPI slave components are written in VHDL and can be used for all FPGAs.
- Configurable data length
- Configurable polarity and phase (All SPI Modes are supported)
- Configurable frequency
| Port name | IN/OUT | length [b] | Port description |
|---|---|---|---|
| CLK | IN | 1 | System Clock |
| reset_n | IN | 1 | Asynchronous Active Low Reset |
| enable | IN | 1 | Initiate Communication |
| cpol | IN | 1 | Clock Polarity Mode |
| cpha | IN | 1 | Clock Phase Mode |
| miso | IN | 1 | Master In Slave Out |
| sclk | OUT | 1 | Spi Clock |
| ss_n | OUT | 1 | Slave Select |
| mosi | OUT | 1 | Master Out Slave In |
| busy | OUT | 1 | Master Busy Signal |
| tx | IN | data_length | Data to Transmit |
| rx | OUT | data_length | Data Received |
| Port name | IN/OUT | length [b] | Port description |
|---|---|---|---|
| reset_n | IN | 1 | Asynchronous Active Low Reset |
| cpol | IN | 1 | Clock Polarity Mode |
| cpha | IN | 1 | Clock Phase Mode |
| sclk | OUT | 1 | Spi Clock |
| ss_n | OUT | 1 | Slave Select |
| mosi | IN | 1 | Master Out Slave In |
| miso | OUT | 1 | Master In Slave Out |
| rx_enable | IN | 1 | enable signal to wire rxBuffer to outside |
| tx | IN | data_length | Data to Transmit |
| rx | OUT | data_length | Data Received |
| busy | OUT | 1 | SLave Busy Signal |
SPI Master and Slave components are available under the GNU LESSER GENERAL PUBLIC LICENSE Version 3.