linslin / phiremock-codeception-extension

Codeception extension and module to make working with phiremock even easier.

phiremock-codeception-extension

Codeception extension and module to make working with Phiremock even easier. It allows to start a Phiremock server specifically for the acceptance tests to run or to connect to an already running Phiremock server.

Installation

Composer:

This project is published in packagist, so you just need to add it as a dependency in your composer.json:

    "require-dev": {
        "mcustiel/phiremock-codeception-extension": "*"
    },
    "minimum-stability": "dev"

NOTE Phiremock uses a dev-master version of react/http to work. Because of this, until reactphp guys tag a new version you will need to set your project's minimum stability to dev.

How to use

Extension

The extension provides an easy way to start a Phiremock server with configured host, port, debug mode and logs path.

Configuration

In codeception.yml you will need to enable Phiremock extension and configure it in a proper way:

extensions:
    enabled:
        - \Codeception\Extension\Phiremock
    config:
        \Codeception\Extension\Phiremock:
            listen: 127.0.0.1:18080 # defaults to 0.0.0.0:8086
            bin_path: ../vendor/bin # defaults to codeception_dir/../vendor/bin 
            logs_path: /var/log/my_app/tests/logs # defaults to codeception's tests output dir
            debug: true # defaults to false
            startDelay: 1 # default to 0

Parameters

• listen: Specifies the interface and port where phiremock must listen for requests
• bin_path: Path where Phiremock "binary" is located
• logs_path: Path where to write the output
• debug: Where to write debug data to log files
• startDelay: Time to wait after Phiremock was started to start running the tests (used to give time to Phiremock to boot)

Module

The module allows you to connect to a Phiremock server and to interact with it in a semantic way through the codeception actor in your tests.

Configuration

You need to enable Phiremock module in your suite's configuration file:

modules:
    enabled:
        - Phiremock:
            host: 127.0.0.1
            port: 18080

Use

The module provides the following handy methods to communicate with Phiremock server:

expectARequestToRemoteServiceWithAResponse

Allows you to setup an expectation in Phiremock, specifying the expected request and the response the server should give for it:

    $I->expectARequestToRemoteServiceWithAResponse(
        Phiremock::on(
            A::getRequest()->andUrl(Is::equalTo('/some/url'))
        )->then(
            Respond::withStatusCode(203)->andBody('I am a response')
        )
    );

haveACleanSetupInRemoteService

Cleans the server of all configured expectations, scenarios and requests history.

    $I->haveACleanSetupInRemoteService();

dontExpectRequestsInRemoteService

Cleans all previously configured expectations and requests history.

    $I->dontExpectRequestsInRemoteService();

haveCleanScenariosInRemoteService

Cleans the state of all scenarios (sets all of them to inital state).

    $I->haveCleanScenariosInRemoteService();

seeRemoteServiceReceived

Allows you to verify that the server received a request a given amount of times. This request could or not be previously set up as an expectation.

    $I->seeRemoteServiceReceived(1, A::getRequest()->andUrl(Is::equalTo('/some/url')));