Klipper_ESP32

Klipper_ESP32 is an implementation of the Klipper protocol for Espressif's ESP32 microcontroller set.

Important Notice

Klipper_ESP32 acts as a wrapper on the original Klipper protocol from the master branch of the Klipper repository, utilizing the underlying Klipper source to facilitate communication between ESP32-based chips and the Klipper software. Please note that this project is currently experimental and not stable. We are not responsible for any damages caused by using this framework.

Installation and Usage

Prerequisites

Before using Klipper_ESP32, ensure you have the following prerequisites installed:

ESP-IDF >= 5.2.1 development environment set up.
Klipper firmware source code.

Setup Steps

Clone the Repository:

git clone --recursive https://github.com/nikhil-robinson/klipper_esp32

Navigate to the Project Directory:
```
cd klipper-esp32
```
Configure ESP-IDF:

Follow the instructions in the ESP-IDF documentation to set up your environment.
Build the Firmware:
```
idf.py build
```
Flash the Firmware:

Connect your ESP32 board and run:
```
idf.py -p PORT flash
```
Replace PORT with the port your ESP32 is connected to.
Configure Klipper Settings:

Configure your 3D printer settings in the printer.cfg file.
Connect and Start Printing:

Connect your 3D printer hardware to the ESP32 board, power on your printer, and start sending G-code commands to Klipper running on ESP32.

Contributing

Contributions to Klipper_ESP32 are welcome! If you have suggestions for improvements or new features, feel free to open an issue or submit a pull request.

Licensing

Please refer to the individual source files within the klipper _esp32 for detailed licensing information.

Acknowledgements

This project is not officially endorsed by the Klipper project. Please refrain from directing any support requests to the Klipper project.

Klipper by Kevin O'Connor

kluoyun / klipper_esp32