Rust project for the Arduino Nano used as i2c master to test i2c slave implementation.
To trigger i2c transactions interruption is used. I2C used an external pullup resistors.
]
-
Specify
RAVEDUDE_PORT
in.envrc
if direnv is used. If you're on linux with nix, change env var inflake.nix
-
Install prerequisites as described in the
avr-hal
README (avr-gcc
,avr-libc
,avrdude
,ravedude
). -
Run
cargo build
to build the firmware. -
Run
cargo run
to flash the firmware to a connected board. Ifravedude
fails to detect your board, check its documentation at https://crates.io/crates/ravedude. -
ravedude
will open a console session after flashing where you can interact with the UART console of your board.
Licensed under either of
- Apache License, Version 2.0 (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)
- MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT)
at your option.
Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.