khimaros / chibios-xz

Fork of bunnie's Burning Man badge project to modernize and simplify the build process.

Burning Man 2020 Badge Instructions

Main differences from 2017 to 2020 badge:

• Batteries are not interchangeable -- connector polarity is swapped between the two
• New charger circuit -- should have less problems with badges needing a kickstart after a long period of disuse
• No microSD card cage to get tangled in clothing
• Radio Tx/Rx LED status
• Goth color scheme
• "2020" decal on back

Hardware

Schematics: http://bunniefoo.com/bunnie/phage-2017-evt1.pdf

Case design: http://bunniefoo.com/bunnie/bm2017-assembly.step

Getting Started

We assume you are building on Debian Bookworm (x86_64)

1. Checkout this repository.
2. Checkout submodules git submodule update --recursive --init
3. Follow instructions in src/lib/README.txt
4. Change to the src dir
5. Run make -j3

The build result will be "build/bm20.elf", an object file that can be loaded using openOCD into the badge.

Connecting the SWD via OpenOCD

We'll use the GPIOs on the Raspberry PI to communicate with badge over the SWD bus to load the firmware.

• Connect SWD to "GPIO 21"
• Connect SWC to "GPIO 20"
• Connect SRES to "GPIO 12"
• Connect a GND

The pin numbers are labelled on the headers on the component side of the board (non-OLED side).

It's recommended you solder any headers with the pins facing toward the component side (not toward the OLED side) so that firmware updates are still possible using a pogo pin jig. The pogo pins come down from the OLED side, so putting the pins facing outward will (a) cause you to be poked by the pins as you wear the badge and (b) interfere with the pogo pins for reflashing using the production jig.

You need to compile OpenOCD from source, and enable "bcm2835gpio". Install the toolchain. If you're using Raspbian, it's something like this:

sudo apt-get install build-essential libtool gdb which
git clone --recursive git://git.code.sf.net/p/openocd/code openocd
cd openocd
./bootstrap
./configure --enable-bcm2835gpio --enable-sysfsgpio --disable-werror
make
sudo make install

Then, run OpenOCD:

cd chibios-bm20/src
sudo openocd -f bcm-rpi.cfg

Loading the ELF File

In gdb, run "load [path-to-build]/build/bm20.elf" to upload the new OS to the board.

Attaching GDB for debugging

If you've compiled your program using a normal toolchain, you can use GDB to load code and debug the software. From your Desktop, run:

arm-none-eabi-gdb -ex "target remote 192.168.xxx.xxx:3333" [path-to-your-program].elf

To look at OS threads in GDB, add the symbols from the orchard.elf file you built at load address 0:

(gdb) add-symbol-file [path-to-orchard.elf] 0

You should now be able to look at threads using "info thr", and change threads with "thr [pid]".