kedzior-io / LilyGo-T-Call-SIM800

🌟LilyGo T-Call SIM800 Series🌟

Product 📷:

Examples	Product Link	Schematic	Status	Recommended level
SIM800L IP5306 20190610	Product link	Schematic	✅	⭐
SIM800L IP5306 20200811	Product link	Schematic	✅	⭐⭐
SIM800L AXP192 20200327	Product link	Schematic	✅	⭐⭐⭐
SIM800C AXP192 20200609	Product link	Schematic	✅	⭐⭐⭐

Datasheet

• SIM800 AT Command
• SIM800 Hardware Design
• AXP192
• IP5306

FAQ

1. If you are unable to download, please try the following steps, if it still does not work, please contact customer service

1. Open the serial monitor
2. Short IO0 to GND
3. Press the RESET button on the board, if the serial port communication is normal, then you should see

   ets Jun 8 2016 00:22:57
   
   rst:0x1 (POWERON_RESET),boot:0x3 (DOWNLOAD_BOOT(UART0/UART1/SDIO_REI_REO_V2))
   waiting for download
   

4. If you can see the above message, it means that the communication is normal, then all you need is to let it enter the waiting download mode, then you can click upload, usually it can solve the problem of not being able to download automatically

2. About the 5V power pin description on the board:

1. For IP5306 power supply, the 5V power pin on the board is the output, which is boosted by the IP5306 power chip. When using USB and battery, it can provide 5V output. According to the manual, it can provide a maximum output current of 2.4A .

2. When using AXP192 power supply, the 5V power pin on the board is the input, and it is connected with USB 5V+. There is no other power output on the board except for the 3.3V output.

3. Didn’t connect to the Internet for a long time, or just turned off suddenly?

1. It may be due to insufficient USB power supply current, please connect a lithium battery to the board, then plug in the USB and test again.