Blaine Furman's repositories
371_Extra_Credit
371_Extra_Credit class stuff
7-Segment_CMOD_S6
Just backing up my 7 seg CMOD S6 sketch.
8-digit-7-segment-display
This is code to drive a 8 digit 7 segment display from an arduino
Adept2Test
Just a test of the Adept 2 Firmware on a CMOD S6 board
Aloha_Pau_FPGA_Implementation_VHDL
Just a practice of the Aloha Pau Implementation
Arduino_LED_Matrix_Hat
Just a LED Matrix hat
Arduino_LED_Speaker_sweep
Hey Everyone, just a quick project to get a little better at the Arduino IDE
Arduino_Servo_Practice
Moves Two motors on pins in a circle for an arduino autonomous robot
Arduino_Sweep_2
This a second attempt using the tone library
Atmel-Studio---LED-Test-
This was a test for ATmega328P project in Atmel Studio 7. Plug the pin into Pin 13 for the LED and the negative side to ground.
Barely-C-conversion
This is just a small assignment I wanted to back up
EE-160-Backup
Here is both labs and hw
EE_205_Labs
Just a backup of all my labs before I lose them on Laulima
EE_473_Part_2_Calculations
This is just a documentation of my MATLAB code for EE 473
HTML-Learning
This is just from me learning HTML on the side. :) It's not a really creative feat but just so I can keep files up to day from each computer I got.
Lab7-FPGA
Just a backup of the code I have for this lab
LVDS_CMOD_S6_VHDL
Just a LVDS example
MCP4821_EP_CMOD_S6_Implementation
This is a short VHDL program that will interface with a DAC (MCP4821)
Perl_Practice
Backing up iSH perl stuff
Progressive_Webapp_Game
Just practicing some CSS and JavaScript
Pynq-Z2-XDC-and-Board-File
This is just a backup of these files incase TUL's website goes down or gets lost.
Raspberry-PI-Test-PCB
Just a simple board supplying a I2C mux, EEPROM, DAC, and ADC
React-Website-3d-printing
Just some practice with React
SnakeSFML
This is just a crappy snake game in sfml. It's not complete yet
VHDL_if_statement
This is really, really simple. I'm just keeping it up for my own reference lol
Xilinx_training
This is a dump of all of the training labs
Zynq_Example_Code
Hello. This is a recreation of the example code that ships with the Pynq Z2. The buttons can be pressed to make the leds light up and the RGB leds cycle through colors at 1HZ.