joelsernamoreno / EvilCrowRF-Beta

Documentation, gerbers, design and schematic.

EvilCrowRF-Beta

Documentation, gerbers, design and schematic.

Implementation and development: Joel Serna (@JoelSernaMoreno)

PCB design: Ignacio Díaz (@Nacon_96) / Forensic&Security (@ForensicSec)

The developers and collaborators of this project do not earn money with this. You can invite me for a coffee to further develop Low-Cost hacking devices. If you don't invite me for a coffee, nothing happens, I will continue developing devices.

Disclaimer

Evil Crow RF is a basic device for professionals and cybersecurity enthusiasts.

We are not responsible for the incorrect use of Evil Crow RF.

We recommend using this device for testing, learning and fun :D

Introduction

Evil Crow RF is a radiofrequency hacking device for pentest and Red Team operations, this device operates in the following radiofrequency bands:

• 300Mhz-348Mhz
• 387Mhz-464Mhz
• 779Mhz-928Mhz

Evil Crow RF uses 2 CC1101 modules, these modules can be configured to transmit or receive on different frequencies at the same time.

Evil Crow RF allows the following attacks:

• Signal receiver
• Signal Transmitter
• Replay attacks
• ...

This device is similar to the device developed by Samy Kamkar (@samykamkar): https://www.wired.com/2015/08/hackers-tiny-device-unlocks-cars-opens-garages/

In this repository you can find a basic PCB to mount your own Evil Crow RF (the full version of Evil Crow RF is still under development).

In this repository you can also find some BASIC sketches for Evil Crow RF. Sketches for replay or rolljam attacks are not published for ethical reasons.

Hardware

To mount your own Evil Crow RF you need the following hardware:

• 1x Evil Crow RF PCB

• 2x CC1101 module

• 1x Micro SD

• 1x OLED

Libraries

Evil Crow RF needs the following libraries:

• https://github.com/LSatan/SmartRC-CC1101-Driver-Lib

• https://github.com/sui77/rc-switch

• https://github.com/davetcc/IoAbstraction

• https://github.com/arduino-libraries/SD

Installation

1. Download and Install the Arduino IDE: https://www.arduino.cc/en/main/software

2. Download and save the required libraries in the library directory

3. Open any sketch from this repository with the arduino IDE

4. Select Tools - Board - Arduino Nano

5. Select Tools - Processor - Atmega328P

6. Upload sketch and fun!!

Demo sketch

oled-example: Simple skecth to use the oled display.

EvilCrow_rf_testbuttons Simple sketch to use the PushButton.

TXDemo: Simple sketch to transmit with a CC1101 module.

RX-315mhz-433mhz: Sketch to receive with two CC1101 modules at the same time.