joeferner / voron

My Voron settings and info

Additional Parts

• Big Tree Tech HDMI5 Mount

Z Calibration

using 0.15mm feeler gauge

G28
BED_MESH_CLEAR 
QUAD_GANTRY_LEVEL
G28
G1 X150 Y150 Z1 F6000
Z_ENDSTOP_CALIBRATE

Input Shaping

• https://mellow.klipper.cn/#/advanced/usb_adxl
• https://github.com/VoronDesign/Voron-Stealthburner/blob/main/STLs/Stealthburner/ADXL345_Mounts/sb_adxl_mount_generic_15.5mm_c_c.stl

Skew Calibration

• https://www.thingiverse.com/thing:2972743/files
• https://www.klipper3d.org/Skew_Correction.html

Upgrade Klipper Firmware

sudo service klipper stop
cd ~/klipper
make clean
make menuconfig
make
make flash FLASH_DEVICE=/dev/serial/by-id/$(ls /dev/serial/by-id/ | grep stm32f446)
sudo service klipper start

Info

• Voron parts were printed with ABS+Glass Fiber filament from Phaetus

Notifications

• Mooncord

Print Settings

• Printer -> Machine G-code
  • Matchine start G-code (add): PRINT_START EXTRUDER=[nozzle_temperature_initial_layer] BED=[bed_temperature_initial_layer_single] Chamber=[chamber_temperature] PRINT_MIN={first_layer_print_min[0]},{first_layer_print_min[1]} PRINT_MAX={first_layer_print_max[0]},{first_layer_print_max[1]}
  • Layer change G-code: M117 Layer {layer_num+1}/[total_layer_count] : {filament_settings_id[0]}
• Layer height: 0.2 mm
• Line width -> Default: 0.4 mm
• Infill percentage: 40%
• Infill type: grid
• Wall count: 4
• Solid top/bottom layers: 5
• Supports: NONE

Troubleshooting

Klipper connection

journalctl -u klipper.service
# if c_helper.so
rm -rf /home/biqu/klipper/klippy/chelper/c_helper.so