jneilliii / OctoPrint-TasmotaMQTT

jneilliii/OctoPrint-TasmotaMQTT Issues

not sending MQTT requests for new devices
Closed 3 months ago4
icon keeps rotating with changed 'full topic'
Updated a year ago15
My plug with tasmota won´t work with this plugin
Closed 2 years ago6
Request: Labels for Relays
Closed 3 years ago3
when no relay number is supplied, don't show |
Closed 3 years ago
PR?: Added support for onConnect / onDisconnect events + Some configurable UI changes
Closed 3 years ago4
[Feature Request] Add custom @ and action commands for gcode control
Closed 3 years ago2
M81 Command Prior To Print Causes Ender3 to Shutdown
Closed 3 years ago3
Invert Relay for Normally Closed SONOFF Relay
Closed 3 years ago7
Ability to change "StateText-s"
Updated 3 years ago6
Not getting power state on relay 1 of multichannel sonoff
Closed 3 years ago4
[FR] Ability to turn on printer without using GCode
Closed 3 years ago8
Switch turns on but icon keeps spinning (new ON state not recognised)
Closed 3 years ago5
Can't seem to get it to work right
Closed 3 years ago2
Not working - sending %fullTopic%/POWER with no arguments
Closed 3 years ago13
Shut-down clock triggered upon start-up
Closed 4 years ago19
Turning on Relay(s) on file upload to OctoPrint server
Closed 4 years ago7
New update gcode handling
Updated 4 years ago11
'Automatic Power Off' should not happen if switch is already off
Closed 4 years ago4
Can't use M80 and a parameter with Reptier
Closed 4 years ago27
Plugin can't be loaded / doesn't do anything / buttons don't work
Closed 4 years ago2
Possible to use this in a different plugin?
Closed 4 years ago3
State topic changed
Closed 4 years ago13
update to 0.3.6 wiped configured units
Closed 4 years ago3
Request: possibility to cancel switch off
Closed 4 years ago1
Power off after idle for some time.
Closed 4 years ago6
auto discovery ?
Updated 5 years ago6
How to configure ? sending incorrect payload
Closed 5 years ago6
user/pass for the broker?
Closed 5 years ago4
OpenHab trigger the plugin?!
Closed 5 years ago6
Clarification on topic
Closed 5 years ago4
Autoconnect fails if already connected
Closed 5 years ago4
Improve documentation alittle
Closed 5 years ago3
Stat is not received for %topic%/%prefix%/
Closed 5 years ago3
Plugin not working
Closed 5 years ago7
Plugin can't detect power state of tasmota
Closed 5 years ago2
Can't send M80 command while printer is disconnected
Closed 5 years ago3
Power on and off not working
Closed 6 years ago18
No Ip On Setup Tab After Install
Closed 6 years ago3
Plugin does not check whether printer is currently printing when powering off after gcode delay
Closed 6 years ago2
Feature Request: configured MQTT topic
Closed 6 years ago3
Doesn't gracefully disconnect before GCODE off
Closed 6 years ago4
GCODE ON/OFF commands don't support single relay
Closed 6 years ago2
Sonoff POW
Closed 6 years ago2
Works great - a couple of suggestions
Closed 7 years ago7