Turnstile - Local Git Hooks
Configurable local git hooks.
Installation
You can install turnstile using pip:
$ pip install turnstile-core
Alternatively, you can install it using setup.py:
$ setup.py install
Adding and removing turnstile from a repository
To use turnstile in a repository, run turnstile install
inside the repository.
To remove turnstile from a repository, run turnstile remove
inside the repository.
Configuring turnstile
You can configure the global hook behaviour by running turnstile config
.
Currently you can only configure the hook verbosity.
Repository configuration
To use turnstile, you need to add a configuration file named .turnstile.yml
to your repository.
You can find an example configuration in turnstile repository and can learn more about the configuration options in the documentation.
Adding subcommands
Turnstile looks for command extensions in turnstile.commands
entry points.
To make a new subcommand, create a click command named cmd
and add the module with command
to your setup.py entry points in the 'turnstile.commands' group.
More information
To learn more, check turnstile's documentation.
License
Copyright 2015 Zalando SE
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at
http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.