#Paddle
A 3D-printable paddle controller for Atari-compatible game systems.
##Parts
- 1M linear potentiometer
- SPST NO pushbutton
- DB-9 Female connector
- Cable (at least 4 conductor, CAT-5 perhaps?)
- Printable parts: knob, case top, case bottom (other?)
Paddles are normally a pair connected to a single DB-9 connector which uses one controller port.
##Pinout
1 <- NC
2 <- NC
3 <- Right switch
4 <- Left switch
5 <- Left pot
6 <- NC
7 <- Pot ground (shared)
8 <- Switch ground (shared)
9 <- Right pot
##References