Unofficial port of the fpgaprog utility to work on OSX, which can be used to
flash or load bit files to the Pipistrello board from Saanlima.
You need to install both libftdi and libusb-1.x, for example, using
HomeBrew:
$ brew install libftdi libusb
Compilation is simply a matter of running make:
$ make
...
$ ls fpgaprog
fpgaprog
To flash bitfiles to the flash memory of your Pipistrello, you need to provide
the correct bscan_spi bit file. Copy the file bscan_spi_lx45_csg324.bit to
a place for later access.
For libftdi to work, you need to unload the FTDI serial driver that is loaded automatically by OSX:
$ sudo kextunload -b com.FTDI.driver.FTDIUSBSerialDriver
The fpgaprog program takes the following options:
-v Enable verbose output;
-j Detect JTAG chain, nothing else;
-d FTDI device name;
-f <bitfile> Main bit file;
-b <bitfile> bscan_spi bit file (enables spi access via JTAG);
-s [e|v|p|a] SPI Flash options: e=Erase Only, v=Verify Only, p=Program Only or a=ALL (Default);
-c Display current status of FPGA;
-C Display STAT Register of FPGA;
-r Trigger a reconfiguration of FPGA;
-a <addr>:<binfile> Append binary file at addr (in hex);
-A <addr>:<binfile> Append binary file at addr, bit reversed.
To load (not flash) a bit file:
fpgaprog -v -f <bit_file>
To flash a bit file, you need to enable the SPI port to the flash chip through the JTAG port:
fpgaprog -v -f <bit_file> -b path/to/bscan_spi_lx45_csg324.bit -sa -r
The code is licensed under GPLv2. All modifications made by me (JaWi) are licensed under GPLv2 as well.
This code is based on the source code provided by Magnus Karlsson from Saanlima and can be found here: