OpenTama - An open-source reference design for MCUGotchi

Synopsis

OpenTama is an open-source development board serving educational purposes, specifically designed for MCUGotchi using KiCad.

It features:

a low-power STM32L072CBT MCU
either a backlit 128x64 LCD UC1701x or a 128x64 OLED SSD1306 display
an RGB LED for notifications
a piezoelectric speaker
a 1000mAh battery
a USB C connector for data and charging
three buttons

Being an open-source hardware design, anyone can manufacture his/her own board. Furthermore, all components have been placed on the top side of the board, so that the assembly as well can be performed by EMS such as JLCPCB, even for small quantities. The battery and screen must be soldered manually.

Build instructions

Hardware

Make or buy an OpenTama board

If you decide to build it, please note that the JLCPCB references for all the components have already been provided in the project. However, those have been selected depending on their availability at a specific point in time, and will probably need adjustments if you decide to go with JLCPCB.
Decide if you want an SSD1306 OLED screen or a UC1701x LCD screen, and buy it

The UC1701x LCD is a low power display compared to the SSD1306 OLED that drains way more power. However, if you plan to use the MCUGotchi firmware, the highest power consumption will come from the MCU that will not really have time to sleep, so your choice will not have a big impact on the overall power consumption.

If you want to use an SSD1306, the board expects a regular 7-pin 0,96" integrated module. However, if you want a UC1701x, you just need the LCD itself, and you can either choose an FPC one (0.5mm pitch, 14 pins), or one that needs to be soldered (0.6mm pitch, 14 pins).
For reference, we used this one.
Buy a a battery

The design has been made assuming a 1000mAh 40x30x12mm Li-Po/Li-ion battery.
For reference, we used this one.
Plug or solder the display
Solder the battery
Your OpenTama board is ready !

Software

Build the firmware of your choosing

For instance, checkout the MCUGotchi repository and follow the instructions to build it for the OpenTama board.
Get and build dfu-util
Boot the board in DFU mode

Close the BOOT0 jumper at the top of the board, and while doing so, trigger a reset by connecting together the NRST and GND pins at the right of the board.

Program the board using dfu-util

$ cd mcugotchi
$ sudo make flash

$ sudo dfu-util -a 0 -s 0x08000000:leave -D <firmware.bin>

Enjoy !

License

OpenTama is distributed under the CERN-OHL-S v2 license. See the LICENSE file for more information.