mkinitcpio-bluetooth

mkinitcpio hook to enable bluetooth connectivity during boot.

Instructions

This hook has been set up to be used with mkinitcpio and has been tested solely on an Arch Linux x86_64 installation that uses refind-efi instead of GRUB.

Prerquisites

The hook does not work together with the systemd hook in /etc/mkinitcpio.conf
For this hook to operate, the following packages are required: dbus, bluez, bluez-utils
It relies on the AutoEnable=true setting in /etc/bluetooth/main.conf

Boot process & a note for Manjaro users

Please be aware that just like any other additional module, the hook adds to your kernel image. To operate, it hence requires your kernel to be available during boot, before you are asked for a passphrase. A supported setup therefore strictly requires your /boot partition to not be encrypted.

If you are a Manjaro user and installed your system using their setup assistant, there is a high likelyhood of your /boot partition also being encrypted. In that case this hook won't work for you as you are prompted by GRUB early on, before your kernel and hence this module is available. Please refer to this Manjaro post for options to make your boot process support this hook.

Preparations

If you haven't already, make sure you have paired, connected and trusted your bluetooth keyboard. Instructions can be found on the ArchWiki here.
Ensure both your bluetooth keyboard and your system startup process are operational without issues at this point
Check that AutoEnable is enabled in /etc/bluetooth/main.conf

Setup

Download or clone this repository to your machine and change into it
Run makepkg to install this hook
Add bluetooth to your HOOKS array in /etc/mkinitcpio.conf before encrypt and after keyboard

Example: HOOKS=(base udev autodetect modconf keyboard keymap bluetooth block encrypt lvm2 filesystems fsck)
(if needed) Add any file, binary, module that your keyboard or bt adapter might need

Example:
```
FILES=(/usr/lib/firmware/intel/ibt-20-1-3.sfi) 
MODULES=(usbhid xhci_hcd)
```
Rebuild your initramfs with mkinitcpio
Upon next reboot, your keyboard should become operational automatically just before cryptsetup asks for your passphrase

Troubleshooting

If you have trouble finding what module, file, binary you need for your keyboard or bt adapter, try looking for errors in dmesg and journalctl related to bluetooth.

Example:

# journactl | grep bluetooth
kernel: bluetooth hci0: Direct firmware load for intel/ibt-20-1-3.sfi failed with error -2
# dmesg | grep bluetooth
[    1.717123] bluetooth hci0: Direct firmware load for intel/ibt-20-1-3.sfi failed with error -2

irreleph4nt / mkinitcpio-bluetooth