hisi-idt
A tool for downloading binaries to soc ram and ddr through serial port.
- Command
sudo python hisi-idt.py -d device --img1 --img2 or sudo python hisi-idt.py -d device --img1 <l-loader.bin>
- Download Steps
a. Insert USB cable and connect with PC; b. Enter force downloand mode:
For LCB board: short J15 / Pin 3-4;
For EVB board: press “Force Download” key + “Reset” key, and then
release “Reset” key then will enter into “force download” mode;
c. Check if there have the device node “/dev/ttyUSBx”, if there have device node that means the PC has detected the target board; d. Use command "sudo python hisi-idt.py" to run the script; after idt download binaries successfully, it will print out below log:
+----------------------+
Serial: /dev/ttyUSB1
Image1: fastboot1.img
Image2: fastboot2.img
+----------------------+
Sending fastboot1.img ...
Done
Sending fastboot2.img ...
Done
- Burn Images
After download fastboot1.img and fastboot2.img on the board, then can use fastboot command to burn images:
sudo fastboot flash fastboot1 fastboot1.img sudo fastboot flash fastboot fastboot2.img
- Troubleshooting
a. After enter the force download mode, if Ubuntu PC cannot recognize the device ttyUSBx; this issue can be fixed by input below commands: sudo echo 12D1 3609 > /sys/bus/usb-serial/drivers/option1/new_id sudo makenod /dev/ttyUSB0 c 188 0
b. Need supervisor permission for hisi-idt.py: "sudo python hisi-idt.py"
c. Need supervisor permission for fastboot: "sudo fastboot"
d. If download binaries failed with below message:
Sending fastboot1.img ...
failed
failed
Usually this means you are using the wrong ttyUSBx device; the reason
is when connect board with the uart cable and usb cable, then PC will
create two device nodes /dev/ttyUSB0 and /dev/ttyUSB1;
But the nodes which are randomly binding to uart and usb, so sometimes
/dev/ttyUSB0 is created for the uart and /dev/ttyUSB1 is for the usb
port, in this case should use /dev/ttyUSB1 for the idt; if PC exchanges
the nodes then should use /dev/ttyUSB0.